Peerless Cartridge Faucet Repair
- Turn off the water.
- Remove the handle.
- Unscrew the retaining nut, using locking pliers.
- Grasp the valve stem with pliers and lift out the cartridge. If it's stuck, pour in some vinegar to dissolve the mineral deposits binding it. ...
- Check inside the valve housing for rubber gaskets in the inlet holes and lift out any you find using a screwdriver.
- Replace the cartridge and all the O-rings and gaskets. A Peerless faucet cartridge along with all its O-rings usually costs less than $20, so the repair shouldn't be expensive.
How to repair a Moen two handle bathroom faucet?
Remove the Faucet Handle
- Remove the handle adapter. This is the piece connected to the cartridge using a Philips screw. ...
- Lift off the flange. It is decorative piece that you only need to lift off.
- Unscrew the plastic ring. It could be hand-tight but sometimes you may need to use a wrench to loosen it.
How to replace a diverter valve in a peerless faucet?
Two-Handled Faucet Diverter
- Reach under the sink to rotate the hot and cold water supply valve clockwise. ...
- Place a rag over the cap behind the two-handled faucet spout. ...
- Insert a butter knife or a nickel into the slot at the top of the diverter. ...
- Wrap the clean diverter threads in one or two layers of thread-seal tape. ...
- Replace the faucet cap on the faucet body. ...
How to repair a leaky tub and shower faucet?
- Clear any rust, wax or caulk from around the base.
- Use an adjustable wrench to loosen the bolts that hold it together. ...
- Remove the stem and install a new one in the fitting using new bolts. ...
- If the bathtub faucet is still dripping after replacing the handle, washer and stem, you may need to replace the entire bathtub spout.
How do I repair a Grohe Ladylux plus faucet?
Typical questions asked about products:
- Is the product durable?
- Is the product easy to use?
- What are the dimensions of the product?
How do you disassemble a peerless faucet?
0:004:37Delta Peerless Bathroom Single Handle Faucet Repair - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd just use a small slotted screwdriver and pry off the decorative cover to loosen that set screwMoreAnd just use a small slotted screwdriver and pry off the decorative cover to loosen that set screw you can use 1/8 inch allen wrench or you can get this combo tool and this has 1/8 inch allen wrench.
How do you remove a Peerless bathroom faucet cartridge?
0:455:31Delta/Peerless Faucet Cartridge Installation - YouTubeYouTubeStart of suggested clipEnd of suggested clipTurn it off by turning these a quarter of a turn. We turn off both sides. Because water can flowMoreTurn it off by turning these a quarter of a turn. We turn off both sides. Because water can flow from one side of the other when you take this assembly apart.
How do you stop a peerless faucet from dripping?
What do I do if my single-handle kitchen or lavatory faucet drips from the aerator?Remove the aerator (it should twist off by hand).Turn off the water supplies.Turn the faucet handle to the "on" position.Turn the water on at the supply.Flush the faucet and supply lines for one minute.More items...
Why is my peerless faucet dripping?
If your Peerless faucet is leaking from under the handle, it's usually because the retaining nut holding the cartridge or ball valve is loose. Luckily it can be fixed in a couple of simple steps: To access it, you have to remove the handle and the dome-shaped collar. Then, you can tighten it with pliers.
How do you remove a peerless faucet handle without a visible allen screw?
If the set screw is visible, hold the faucet in place and tighten the screw. If you can't see the screw, it will be under the cap, which you can remove with a flathead screwdriver or your small knife. Tighten the screw while holding the handle in place. Once the screw is tight, the handle should stop shaking.
How do you take apart a single handle bathroom faucet?
1:204:00How to Replace the Seats & Springs in a Single Handle Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipUse the needle nose pliers to unscrew the adjusting ring. Place a cloth over top and use the channelMoreUse the needle nose pliers to unscrew the adjusting ring. Place a cloth over top and use the channel lock pliers to unscrew the cap. Now pull out the ball the cam and packing.
How do you remove a peerless faucet stem?
Look for the nylon locknuts holding the body of the faucet to the countertop or sink. The locknuts twist onto two threaded shanks connected to the underside of the Peerless faucet body. Rotate the locknuts counterclockwise to remove them from the shanks and release the faucet.
How do you tighten a peerless faucet?
Use pliers or the tip of a screwdriver to push the plastic washer under the handle (now on top of the faucet head) left to loosen it. Then push it back right to tighten it, reassemble the faucet and test it.
How do you fix a leaky single handle faucet?
0:182:44Repairing a Leaky Single Handle Ball-Type Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst you will need to turn off the hot and cold water supply valve under the sink next. You willMoreFirst you will need to turn off the hot and cold water supply valve under the sink next. You will need to remove the single lever handle. This may require using an Allen wrench to loosen the handle.
How do you fix a leaky faucet with two handles?
1:382:54How To Fix A Dripping or Leaky Double Handle Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst take off the handle. Then unscrew the valve stem on the stem remove the old gasket screw. AndMoreFirst take off the handle. Then unscrew the valve stem on the stem remove the old gasket screw. And seat washer. Apply some plumbers grease.
Where is the model number on a peerless faucet?
Your faucet's model number may be found on the packaging, and also on the Installation instructions provided with your faucet.
Do they still make Peerless faucets?
Some Peerless faucets are still manufactured in Delta's North American plants. Masco is one American faucet manufacturer that has resisted exporting all of its manufacturing to China. Delta makes faucets in Greensburg, Indiana; Jackson, Tennessee; and Morgantown, Kentucky.
What do I do if my single handle faucet leaks under the handle?
This is a little tricky, but we’ll get you through it. On a single handle faucet, you need to tighten the adjusting ring or replace the cam and packing.
What do I do about water dripping from the spout of my two-handle kitchen or lavatory faucet?
First, you cry. Then you find out that it’s an easy fix. And you feel a whole lot better. A leaking spout is a good indication that your faucet’s seats and springs are worn (which happens with normal wear). To stop the leak, all you have to do is replace the seats and springs by following these steps:
What do I do about water flowing from my diverter tub spout while it is in the shower mode?
First of all, how big a stream of water are we talking about? If you’re got the shower on, and the flow from the tub spout is about as big around as a pencil or pen, that’s actually pretty normal. But if it’s bigger than that, you’ve probably got a problem with the diverter located in the tub spout. Unfortunately, this isn’t repairable. The tub spout must be removed, and replaced with a Genuine Peerless tub spout.
What do I do if my single-handle kitchen or lavatory faucet drips from the aerator?
Either your faucet has sediment or debris in it. If that’s not the problem, you’ll need to replace your seats and springs.
What do I do if water leaks from my kitchen spout while my vegetable spray is in use?
If no one sensitive is in earshot, you might start by swearing a few mild oaths. Then read on. We think the problem may be a blocked or damaged diverter assembly. Follow these steps to solve your leak:
What should I do if water is leaking behind the wall of my tub/shower valve?
There are some problems that even an experienced do-it-yourselfer shouldn’t tackle—and this is one of them. Shut off the water supplies to your tub/shower valve. If you can’t find those, shut off all the water to your house using your main shut-off valve. Then call a licensed professional plumbing contractor for assistance.
Why doesn't my pop-up sink stopper stop the water from draining?
First, look underneath the sink and check to be sure that the strap assembly that operates the stopper is properly adjusted, and that the nut holding the horizontal rod in the drain assembly is secure. Be sure the stopper is properly adjusted.
