how to repair a rip in a down coat

• Push loose down back into the jacket
• Clean the area around the tear. Use an alcohol-based cleaner to remove grease as well as visible dirt
• Cut your patch or repair tape to size, to completely cover the hole (tip: circular shapes are better as there are no hard edges to catch and loosen over time).
• Lay the jacket on a flat surface
• Apply the patch, smoothing out any wrinkles

Full Answer

How do you fix a rip in a leather jacket?

Next, poke any stray down back into your jacket. Smooth out the jacket around the damaged area, ensuring the face fabric is clean and dry. Apply the tape over the rip or tear and press down firmly. Smooth the tape from inside to outside edges. A third option is to purchase a pack of nylon repair patches.

How to repair a down jacket?

You can basically end up emptying the whole baffle of the jacket as you continue to pull. Instead, reach behind the hole from the inside of the jacket, pinch the down through the lining fabric and draw it back inside. Furthermore, this guide will give you the know-how you need to make a neat and effective repair to your down jacket.

Can you sew up a rip in a down jacket?

It’s generally not a good idea to try and sew up a rip or a tear in a down jacket. Due to the very lightweight face fabrics used in the construction of most down jackets, you’ll need a very fine needle and thread to do the job, and even tiny needle holes can cause surprisingly dramatic down leakage.

How do you patch a down jacket with feathers?

Here’s what you need: Here’s how to patch your down jacket: Pull feathers back in: If there are any feathers sticking out of the hole, pinch them from the other side and pull them back inside the jacket. Cut the patch: Use your scissors to cut a patch that will cover the hole with about one inch of overlap in every direction.

How do you fix a rip in a down jacket?

How to Repair a Down or Nylon JacketClean the repair area with isopropyl alcohol to remove any dirt or body oils that may prevent a good bond. ... Peel off the backing on a Tenacious Tape Mini Patch or Gear Patch and apply it over the rip, tear, or hole. ... Apply pressure from the center out.

How do you fix a ripped feather jacket?

2:506:54HOW TO FIX A DOWN JACKET [4K HD] Ripped and Tears Repaired ...YouTubeStart of suggested clipEnd of suggested clipIf it were to rub up against something to snag a corner. Rather than smooth surface highly recommendMoreIf it were to rub up against something to snag a corner. Rather than smooth surface highly recommend that you create your patch in a circle the graft area is going to be the adhesive side going to

How do you fix a tear in a winter coat?

Bring the edges of the tear together. Squeeze a thin layer of urethane-based seam sealer on the fabric patch and on the torn area of the garment. Lay the patch firmly over the tear, smoothing it firmly from the centre out to remove any wrinkles or bubbles. Let your repair dry overnight.

Can you refill down jacket?

If you must add new down, definitely open up the inner seams. There will be at least two and probably 4 rows of stitching to cut. Half a pound of down is plenty. 3 Oz of 800 fill down may actually do the trick.

Can you sew a down jacket RIP?

It's generally not a good idea to try and sew up a rip or a tear in a down jacket. Due to the very lightweight face fabrics used in the construction of most down jackets, you'll need a very fine needle and thread to do the job, and even tiny needle holes can cause surprisingly dramatic down leakage.

How do you sew a patch on a puffer jacket?

2:294:03HOW TO Attach a Patch onto Your Jacket Without Sewing MachineYouTubeStart of suggested clipEnd of suggested clipIf you wanna then the best way is to sew it on and even if you decide to iron it on it is stillMoreIf you wanna then the best way is to sew it on and even if you decide to iron it on it is still better to stitch around the patch to make sure that the patch is more firmly attached to the jacket.

How do you sew a tear in a jacket?

0:101:48How to repair a rip in clothing - Sew torn clothes - No machine - YouTubeYouTubeStart of suggested clipEnd of suggested clipJust going in through the same side of fabric. And out through the other side and every now and thenMoreJust going in through the same side of fabric. And out through the other side and every now and then just put your needle through the loop of thread.

How do you Repuff a puffer jacket?

Place the jacket on a hanger and leave in a cool, dry place to start air drying. Every 30 minutes you should take it down off the hanger and fluff it a little by hand, to ensure it maintains shape and puffiness.

How do you sew a tear by hand?

2:074:54Sewing 101: Mending A Tear - YouTubeYouTubeStart of suggested clipEnd of suggested clipSide pick up a little bit of fabric with the needle. And then loop on back to the opposite side andMoreSide pick up a little bit of fabric with the needle. And then loop on back to the opposite side and pick up a little bit more. Fabric. So basically you keep doing that until you reach the end of the

How do you refill down?

Pull handfuls of down out of the pillow and insert them into the comforter opening. Use the end of a baseball bat or the stick end of a broom to press the down filling deep into the comforter. Repeat this procedure one handful at at time until the comforter regains its fluffy texture.

How do you refill a puffer coat?

The Secret: Throw the puffer into the dryer on a low setting on its own, adding a few tennis balls to the machine. While the jacket dries, the tennis balls will bounce around the machine, constantly hitting the jacket like you would fluff a pillow back into shape.

Why do feathers come out of my down jacket?

The feathers start to protrude from the fabric because the down starts to compress or flatten during normal wear as they lose some of their puffiness. Another solution that works quite well is restoring the puffiness of the down, which prevents the quills from piercing the jacket's fabric.

How do you keep feathers from coming out of a puffer jacket?

If all else fails, wear a thin nylon jacket underneath your down-filled jacket to prevent the feathers from clinging to your clothing. Scotchgard products have proven unsuccessful when it comes to keeping feathers inside jackets.

How do you sew a tear in a jacket?

0:101:48How to repair a rip in clothing - Sew torn clothes - No machine - YouTubeYouTubeStart of suggested clipEnd of suggested clipJust going in through the same side of fabric. And out through the other side and every now and thenMoreJust going in through the same side of fabric. And out through the other side and every now and then just put your needle through the loop of thread.

How do I keep the feathers from coming out of my North Face jacket?

You cannot prevent feathers from coming out of a down jacket. Gently pull the feather back inside the fabric to reposition it inside the jacket. Rub over the fabric where the quill protruded to re-align the fabric and close the hole. Over time the down will settle and come out of the jacket less.

How do you fix a tear in a waterproof jacket?

0:041:00How To Repair A Torn Waterproof - YouTubeYouTubeStart of suggested clipEnd of suggested clipThen make sure the fabric around the rip matches up and is laying smooth on a hard surface cut aMoreThen make sure the fabric around the rip matches up and is laying smooth on a hard surface cut a patch of the repair tape that's 2.5 centimeters 1 inch bigger than the rip you want to repair.

How to repair a rip in a Tenacious tape?

Peel off the backing on a Tenacious Tape Mini Patch or Gear Patch and apply it over the rip, tear, or hole. Patch should overlap tear by 0.5" (12 mm) in all directions. Apply pressure from the center out . Smooth out any bubbles and ensure the edges lay flat. If you do a repair before cleaning the gear, wait at least 24 hours for ...

How long to wait to patch a jacket before washing?

If you do a repair before cleaning the gear, wait at least 24 hours for the Tenacious Tape patch to adhere properly before washing it. PRO TIP: Make your repair nearly invisible by using clear, black, red or yellow Tenacious Tape to match the fabric. If you’re patching a hardshell jacket, put the patch on the inside.

How to cover a hole in a jacket?

Cut the patch: Use your scissors to cut a patch that will cover the hole with about one inch of overlap in every direction . If you round the edges of the patch, it will last longer.

How long does it take for a patch to cure?

Apply the patch: Make sure to smooth out the jacket to avoid wrinkles, then press the patch into place with your fingers. The patch will take about 48 hours to fully cure, so be gentle with it for the first couple days.