
Remove the Hydrant Head Remove the hydrant head from the standpipe, using two pipe wrenches. Place one wrench on the standpipe to hold it in place and keep it from turning, and use the other wrench to grip the hydrant head and unscrew it.
Full Answer
How do you install a fire hydrant in a yard?
Dig hole for hydrant approximately 2 feet in diameter and deeper than the bury depth. Flush gravel, debris, etc. out of the supply line before connecting hydrant. Install hydrant with drain hole below frost line.
What should I do if my hydrant is not supporting the hydrant?
If supply line to the hydrant will not support hydrant, use re-bar, length of pipe or other suitable support driven in bottom of pit to help support hydrant. Before filling excavation, turn on water and check hydrant connection for leaks.
Do I need a larger drain field for a hydrant?
If the area where the hydrant is located is low lying or has a tendency to have standing water, a larger drain field or pit may be required to provide the hydrant a place to drain. (c) Fill bottom of pit with 1/2" gravel to a level about 3" above brass drain valve body, to insure adequate drainage.

How do you fix a leak in a Woodford hydrant?
0:382:16Woodford Model Y34 IOWA® Yard Hydrant Repair - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd rotating pliers counterclockwise on the stem replace with a new rod stem and tighten clockwiseMoreAnd rotating pliers counterclockwise on the stem replace with a new rod stem and tighten clockwise using pliers destroy packing inside the assembly by using a flathead screwdriver.
How do you fix an outdoor water hydrant?
9:0912:26How To Fix A Leaking Water Hydrant - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe can grab that brass piece that slides onto the plunger that has the square set screw. Then we canMoreWe can grab that brass piece that slides onto the plunger that has the square set screw. Then we can grab the two side brass pieces. And put them on to that brass piece that goes on to the plunger.
How do I fix a leaky frost free hydrant?
0:432:14How To Adjust Leaking Water Source Frost Proof Yard Hydrant - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you still have a leak turn the water off repeat the loosening of the set screw and again raiseMoreIf you still have a leak turn the water off repeat the loosening of the set screw and again raise the handle five and a half inches or sixty degrees tighten the setscrew. And check for leaks.
How do you repack a yard hydrant?
0:512:09How to Fix a Leak out of the Packing Nut - E-5000 Yard Hydrant - YouTubeYouTubeStart of suggested clipEnd of suggested clipPlace the pivot connector on top of the packing. Nut. Straps of bent inward. To the pivot connector.MorePlace the pivot connector on top of the packing. Nut. Straps of bent inward. To the pivot connector. And lever. Place and tighten the lever bolt through the head casting jaw straps and lever lift.
How do you fix a broken hydrant?
4:477:56How-To Repair An Outside Yard Hydrant - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou can probably use teflon tape my problem a teflon tape is you don't want to tighten it up andMoreYou can probably use teflon tape my problem a teflon tape is you don't want to tighten it up and then have to end up backing it up because then you lose your seal.
How does a Woodford hydrant work?
0:423:01Woodford Y34 Yard Hydrant: - YouTubeYouTubeStart of suggested clipEnd of suggested clipLine it automatically drains through a weep hole underground when the hydrant is in the closedMoreLine it automatically drains through a weep hole underground when the hydrant is in the closed position and the hose is detached.
How do you fix a frost free outdoor faucet?
2:5616:09How To Fix a Leaking Frost Proof Faucet | DIY Plumbing - YouTubeYouTubeStart of suggested clipEnd of suggested clipAfter you change it out put the cap. Back on. And if the leak was up here you've got it fixed. IfMoreAfter you change it out put the cap. Back on. And if the leak was up here you've got it fixed. If you put a vacuum breaker repair kit on it that was designed for yours.
Why is my frost free spigot leaking?
A leaking frost-proof faucet can waste a lot of water, but fixes are simple, whether the problem is the faucet stem washer assembly, the vacuum breaker, or just a loose retaining nut.
How do you replace an outdoor faucet stem?
0:073:59Repair Outdoor Faucet - traditional style - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe same you take out that lower nut and the entire stem. And handle will unscrew with it and on theMoreThe same you take out that lower nut and the entire stem. And handle will unscrew with it and on the bottom you can see the two nuts here yep. You've got a washer held in with the screw.
How do you install a hydrant repair kit?
0:298:00Leaking Yard Hydrant Repair Part 2 Installing Repair Kit - YouTubeYouTubeStart of suggested clipEnd of suggested clipOne thing I didn't share with you guys in the very first video is there's enough that you can loosenMoreOne thing I didn't share with you guys in the very first video is there's enough that you can loosen in there and where the handle actually sits on the shaft that drives that plunger up and down.Leaking Yard Hydrant Repair Part 2 Installing Repair Kit - YouTubehttps://www.youtube.com › watchhttps://www.youtube.com › watchSearch for: How do you install a hydrant repair kit?
How do you replace a hydrant head?
0:483:30Replacing Yard Hydrant Head - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce the set screw is loosened from the yard hydrant head the next thing you're going to want to doMoreOnce the set screw is loosened from the yard hydrant head the next thing you're going to want to do is loosen off the bushing. And the o-rings. Inside the yard hydrant.Replacing Yard Hydrant Head - YouTubehttps://www.youtube.com › watchhttps://www.youtube.com › watchSearch for: How do you replace a hydrant head?
Where are Woodford hydrants made?
in the U.S.A.This model Y34 yard hydrant features adjustable linkage which allows for fine adjustments of the handle. Made in the U.S.A. Made in the U.S.A.Woodford® Freezeless Yard Hydrant with Variable Linkage at Menards®https://www.menards.com › main › plumbing › valveshttps://www.menards.com › main › plumbing › valvesSearch for: Where are Woodford hydrants made?
How do you replace a hydrant stem?
2:115:51Outdoor Hydrant & Faucet Repair - Andy's Pipe Dream - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou're gonna need a pair of pliers. And you're just gonna gently turn it and unscrew it until itMoreYou're gonna need a pair of pliers. And you're just gonna gently turn it and unscrew it until it comes off of the faucet. You should be able to just get the threads loose.
How do you fix an outside water spigot?
3:315:13How to Fix a Leaky Hose Spigot | Ask This Old House - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt could be gone too right so we want to we want to take this washer. Off of this brass screwMoreIt could be gone too right so we want to we want to take this washer. Off of this brass screw there's a kit try try this one what does that look like find its replacement that one goes out.
How do you replace an outdoor faucet stem?
0:073:59Repair Outdoor Faucet - traditional style - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe same you take out that lower nut and the entire stem. And handle will unscrew with it and on theMoreThe same you take out that lower nut and the entire stem. And handle will unscrew with it and on the bottom you can see the two nuts here yep. You've got a washer held in with the screw.
How do you replace a hydrant head?
0:483:30Replacing Yard Hydrant Head - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce the set screw is loosened from the yard hydrant head the next thing you're going to want to doMoreOnce the set screw is loosened from the yard hydrant head the next thing you're going to want to do is loosen off the bushing. And the o-rings. Inside the yard hydrant.