Steps
- Reattach the soft top material ("canvas") to the glass when just part of the canvas has detached so that the glass does not have to be re-centered within the ...
- Open the top slightly so that it is not taut. ...
- Find the seal that was attached but has become unattached, such as the lower edge of the exterior layer of canvas.
- If only a very small part has separated leave it alone. ...
- Clean the mating surfaces with rubbing alcohol.
- Close the roof completely to see where the canvas falls on the glass when pulled gently flat as far in on the glass as it will go, but not ...
- Re-open the roof slightly and re-prop it.
- Apply a strip of double-sided foam tape such as 3M VHB ("very high bond")--foam so that it will conform to any irregularities, preferably black so ultraviolet rays will not ...
- Bring the middle of the area being attached (such as the middle, left-versus-right-wise of the bottom exterior canvas) up to the edge of the tape.
- Stick the canvas to the tape, working outward. The reason to work outward from a central point is so that any "excess" material does not build up at one ...
- Rub down the canvas over the tape firmly and apply some heat--not a great painfully hot amount--with a blow dryer for a thorough bond.
Full Answer
Can you repair a rip in a convertible top?
Look no further. Whether it’s a hole, tear or rip in a soft top or convertible top, the Aquaseal FD Soft Top Repair Kit will have you back on the road with just five easy steps. Step 1: Clean the repair area with isopropyl alcohol to remove any dirt or body oils which may impact a good bond onto the convertible top.
Can a convertible top be repaired from a binding tear?
But binding tears represent a minority of places where a top may need a repair. Instead, most tears happen in other locations. For these convertible top repairs, you’ll need to take the convertible top off the frame for the popular stitch-patch-and-seal job.
How do you fix a damaged soft top?
Step 1: Clean the repair area with isopropyl alcohol to remove any dirt or body oils which may impact a good bond onto the convertible top. Step 2: Trim fraying edges with scissors. Step 3: Apply a piece of Tenacious Tape (included in the Soft Top Repair Kit) over the damaged area.
Can aquaseal FD soft top repair kit be used on convertible tops?
Whether it’s a hole, tear or rip in a soft top or convertible top, the Aquaseal FD Soft Top Repair Kit will have you back on the road with just five easy steps. Step 1: Clean the repair area with isopropyl alcohol to remove any dirt or body oils which may impact a good bond onto the convertible top.
How much does it cost to fix the back window of a convertible?
A new convertible rear window can cost you anywhere from $100 to $400 on parts alone, while labor can set you back another $50 to $150, depending on the rates in your area. The price of a replacement part varies depending on its brand, material, and finish.
How do you repair a plastic window on a convertible top?
2:465:32How to repair a torn window or top on a convertible car ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis is a softened pvc. The same exact material. That we're applying uh the laminex onto. AndMoreThis is a softened pvc. The same exact material. That we're applying uh the laminex onto. And adhesive is designed specifically to adhere to pvc. So it loves to grab onto it and it's a very strong.
How do you replace a rear window on a convertible?
0:552:08Replace convertible top rear window in Los Angeles - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst step was removing convertible top from the frame. Second step cut a new plastic window for theMoreFirst step was removing convertible top from the frame. Second step cut a new plastic window for the top third step installation back invertible top with new replaced rear plastic window.
Can you replace just the window in a convertible top?
Anyone with a one piece convertible top cannot replace the window only. If your window bond is failing (separating from your material) or your window is cracked, scratched or otherwise damaged, there is not an effective way to replace the window only and salvage the rest of your top.
How do you repair plastic windows?
0:189:04How to Repair or Replace the Vinyl in Sunspace Porch Window - YouTubeYouTubeStart of suggested clipEnd of suggested clipAt one of the edges. And it's possible with its just loose at the edge. That. You can pull theMoreAt one of the edges. And it's possible with its just loose at the edge. That. You can pull the spline stretch the vinyl back out and tuck that spline back in on the edge.
Can I use Flex Seal on my convertible top?
0:000:39Fixing a Leaky Convertible Top - Flex Seal® Reviews - YouTubeYouTubeStart of suggested clipEnd of suggested clipI used a flex seal on the inside of my convertible top put it on top like a canvas top on myMoreI used a flex seal on the inside of my convertible top put it on top like a canvas top on my Kawasaki. Miu I've got an older van. And had problems with leaking around the top of the windshield.
How much does it cost to repair a convertible top?
The Estimated Price For Replacing A Convertible Top Runs From $900 To $1500One replacement top (including pop rivets, staples, hold-down cables, and adhesive)A strip of windshield sealer (for those who own a vehicle with glass windows with rubber trim)Silicone spray.
How do you seal a convertible top window?
0:0816:37Reglue convertible glass - 2005 Chrysler Crossfire - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis is window weld by 3m supposed to be the best stuff out there for putting in windows. It alsoMoreThis is window weld by 3m supposed to be the best stuff out there for putting in windows. It also will allow you to glue the canvas to the glass.
What are convertible windows made of?
Vinyl convertible top windows are made of DOT rated 40-guage plastic, and withstand the weather and wear and tear over the years you own your car.
How long will a convertible top last?
A properly maintained convertible top lasts an average of 5-7 years. 2. Never put a convertible top down when the temperature is below 60 degrees.
How do you sew a convertible top?
How to Repair a Convertible TopTools and Materials Needed: Upholstery thread, similar color to your top. ... Step 1: Sew the Wound. Start sewing the tear. ... Step 2: Glue the Seam. Using your fabric adhesive or Gorilla Glue, glue the seam. ... Step 3: Apply the Canvas. ... Step 4: Sew the Inside.
Can you repair a convertible top?
If you have noticed that there is a hole in your vinyl convertible top, you can patch it fairly easy with a repair kit and a little knowhow. Here is an easy guide to fixing a hole in a vinyl convertible top. The first step in the process of repairing your vinyl convertible top is closely inspecting the damage.
How do you repair a vinyl window frame?
How to Repair a Crack in a Vinyl Window FrameStep 1: Clean the area around the crack. ... Step 2: Put on clean gloves and carefully apply vinyl adhesive in and over the crack. ... Step 3: Let it dry 24 hours.Step 4: Using a razor blade, carefully scrape any excess adhesive away.More items...•
How do you fix a tear in clear vinyl?
How to Apply Tear AidCut the patch so that it is one inch bigger than the rip or tear on all sides.Then carefully peel back the paper liner and start to position the Tear Aid over the rip on the fabric.Slowly peel back the liner while carefully applying the patch, taking care to work out any air bubbles.More items...•
What are convertible windows made of?
Vinyl convertible top windows are made of DOT rated 40-guage plastic, and withstand the weather and wear and tear over the years you own your car.
How do you fix a soft top jeep window?
0:2413:19Easy Fix for soft top window, convertible or canopy repair with ...YouTubeStart of suggested clipEnd of suggested clipFrom what I understand smells pretty bad and there's a better product out there from what I've readMoreFrom what I understand smells pretty bad and there's a better product out there from what I've read I'm going to give it a shot but what it is it's called lazer bond.
What happens when you take the top off a convertible?
When you take the top off the frame and start handling it for a repair, you push those limits. One of the most common things that we hear from convertible owners is that when they take their old top off the vehicle, they see that it was in much worse shape than they realized.
What does it mean when a convertible top is taut?
Years of moving the convertible top up and down, making the top taut then loose, changing temperatures from hot to cold, in wet and dry conditions means your convertible top material has been put through extreme contrasts. Quality convertible tops have material that is made to hold up to that stress, but it has limits.
Do you need to use a patch to seal a tear?
So you’ll need to use something to seal your tear and hold the patch and that’s why people use stitching. Stitching, of course, presents issues with waterproofing, so any stitches done will need to be sealed, so you don’t get water through the repair. If you need to use a patch, you’re going to need to remove the top from ...
Can you tear a convertible top?
Also, it’s very common to tear the top when you try to get the glued sleeve off -- after all, it’s glued. When you carefully remove the glued sleeves, you will still be dealing with the fact that convertible topping material can lose its integrity when it’s being handled beyond its normal routine.
Can you use duct tape on a convertible top?
First things first, there are no conventional adhesives which will hold patches on vinyl or clothing convertible top materials. So that’s one of the reasons you see convertible tops with duct tape instead of patches -- there just isn’t an adhesive that does the job well. So you’ll need to use something to seal your tear and hold ...
