
How to Fix a Crumbling Concrete Driveway
- Inspect the driveway for damaged areas. Use a black marker to mark any and all spots that must be removed and replaced.
- Place a straight, 8-foot length of one-by-six next to the chalk line. The board will act as a guide for the cut-off concrete saw to follow.
- Start the concrete saw and score the concrete 1/4-inch deep. ...
- The Cure for Crumbling Concrete Steps.
- Resurface a Spalling Driveway.
- Eliminate Countertop Scratches and Stains.
- Replace Worn Patio and Driveway Expansion Joints.
- Plug Leaky Basement Walls.
Should driveway cracks be repaired?
Replacing a Driveway
- Appearance. If you have a few narrow cracks in your driveway, you can patch them up and be on your way. ...
- Cost. Patching is the least expensive repair at $2 to $3 per square foot, plus the cost of an asphalt squeegee, $20 to $60.
- Durability. Patching a driveway is a temporary fix. ...
- DIY or Pro. ...
How to repair cracks in a driveway?
Use the trowel or small shovel to smooth it out. F or larger cracks, mix your cold patch with water and use your trowel at a 45- degree angle to push it into the crack, and then turn to 90 degrees to smooth the surface.
How to repair a crumbling concrete sidewalk?
While there’s no hard and fast rule, here are some tips to guide your decision:
- Assess the severity of the damage. If your driveway is full of spalled areas and broken edges, the surface is probably severely weakened. ...
- Call in a concrete contractor (Search “Concrete Contractors” on your browser) to help you assess the situation and ask for a price on complete replacement. ...
- Is appearance important? ...
- How much are you willing to spend? ...
How do I remove rust from a concrete driveway?
- Remove excess dirt and debris from the surface of your concrete driveway before removing the stains.
- Make a paste out of baking soda and laundry detergent. ...
- Apply the paste on the stained areas, and make sure that you cover all the rust. ...
- Using a stiff brush, scrub the stained area.
- If there’s still stain residue, repeat the process

How do you fix a crumbled concrete driveway?
1:214:15Extreme How To - Patching and Repairing Concrete - YouTubeYouTubeStart of suggested clipEnd of suggested clipWater. Apply the mix of the trowel using heavy trowel pressure to force the mixture down into theMoreWater. Apply the mix of the trowel using heavy trowel pressure to force the mixture down into the crack overfill slightly and then trowel smooth to match the surrounding concrete.
Can you resurface crumbling concrete?
You can repair and resurface your spalled concrete in any number of ways. You can buy products that apply a very thin coating on the concrete. The larger premixed bagged concrete manufacturers make these, as do some other specialty companies. These products do work, but pay close attention to their limitations.
Why is my concrete driveway disintegrating?
Too much water can wash away the soil supporting your concrete. Too little and it can cause the soil to shrink. And when water freezes and thaws over and over and over and over again, it can cause the surface of your concrete driveway to crack, pit, and crumble.
How do you strengthen crumbling concrete?
Remove all loose material with a small paint scraper, then brush off the dust. You can use packaged masonry or concrete repair mixes, available at home improvement stores, or buy a bottle of concrete bonding agent and a bag of mortar. Brush the bonding agent onto the old concrete and let it sit until tacky.
How long does quikrete concrete resurfacer last?
This new layer is specially made to adhere to the old concrete. It's extremely durable while being relatively thin and can last 10-20+ years if properly installed by a Pro and cared for. So yes it can last. Concrete resurfacing provides a like new finish at an affordable price.
How do you repair an old concrete driveway?
0:394:28How to Resurface Concrete - YouTubeYouTubeStart of suggested clipEnd of suggested clipBefore resurfacing your slab deeply spalled areas and large cracks should be repaired using concreteMoreBefore resurfacing your slab deeply spalled areas and large cracks should be repaired using concrete resurfacer that has been mixed to a triable consistency.
How do you fix a peeling driveway?
1:457:41Concrete Resurfacing - How To Fix Spalled Concrete - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd sometimes the easiest way to get that spalled concrete off is just to lightly grind it that'llMoreAnd sometimes the easiest way to get that spalled concrete off is just to lightly grind it that'll remove all that loose. Stuff you know get us back down to a good concrete base. Now this concrete
Why did my concrete crumble?
The most common cause of spalling is errors on the part of contractors. They either add additional water to the concrete as they finish it or they start to finish the concrete before the concrete bleed water leaves the surface of the concrete.
Why is top layer of concrete flaking off?
Damage will show up when the concrete is exposed to ice or snow which then melts and penetrates into the concrete and freezes. Frozen water expands about 10%, pushing the thin, weak top layer upwards causing the layer to peel off (known as spalling).
How do you seal a crumbling concrete floor?
Prepare the crumbling area for a coat of new concrete. ... Create a slurry mixture by combining pure cement with water in a bucket. ... Apply a coat of the cement slurry mixture on your previously crumbled area, using a paintbrush. ... Cover the cement slurry with some of your concrete mixture.
Why did my concrete crumble?
The most common cause of spalling is errors on the part of contractors. They either add additional water to the concrete as they finish it or they start to finish the concrete before the concrete bleed water leaves the surface of the concrete.
What is it called when concrete crumbles?
Spalling or Crumbling Concrete. As unfortunate and time-consuming as it can be, concrete does need to be properly maintained and taken care of over time. Many people do not realize that concrete can't just be poured and left, and this is what can lead to problems down the line.
How do you repair damaged concrete?
2:334:13How to Make Thin Repairs to Damaged Concrete with QUIKRETEYouTubeStart of suggested clipEnd of suggested clipDampen the repair area with water. Enough water should be used to saturate the surface. Although anyMoreDampen the repair area with water. Enough water should be used to saturate the surface. Although any standing water should be removed vinyl concrete patcher should be built up in layers using a margin
How do you fix crumbling concrete basement walls?
0:454:23Shotcrete: The Remedy For Crumbling Walls - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo shotcrete is not only a great application for a lot of different surfaces. But also a lot ofMoreSo shotcrete is not only a great application for a lot of different surfaces. But also a lot of different shapes or older homes that might have been deteriorating crumbling things that are falling
Why is my concrete crumbling?
This type of damage may be caused by a bad batch of concrete where potential chemicals were added, or the concrete had too much water added when poured. The crumbling can also be caused from extreme exposure to outside chemicals like salt or acids.
Why is my driveway worn down?
Your entire driveway is worn down to rubble, usually caused by long periods of time, extremely bad batch of concrete, or unbelievable abuse of concrete. This is the worst case scenario and most likely completely beyond DIY repair.
1. Determine the problem areas
The process of fixing the crumbled concrete driveway begins by determining the problem areas. If it has minor damage, then you can do it yourself. Otherwise, call a professional to fix your driveway.
3. If you plan to do it yourself, start by thoroughly cleaning the working area
The patching process begins by making sure the working area is cleaned. Remove the crumbled concrete, and sweep off the dust and foreign materials. You can also use a pressure washer to blast off difficult-to-remove dirt. If you used a pressure washer, make sure the area dries first before proceeding.
4. Prepare the concrete mixture
While the driveway pavement is drying after the pressure washing, prepare the concrete mixture. Be sure to use concrete with high strength to make it long-lasting. Before mixing, make sure the water ratio is enough to make it have a consistency similar to peanut butter.
5. Fill the damaged area with concrete
Use a shovel to fill the damaged area with the concrete mixture. Using a trowel, make sure to even the surface to the driveway’s elevation. Let it dry for a few hours, then apply the second concrete coating. However, the second coating should have a wetter consistency for a smoother finish.
6. Use a concrete finishing broom
Using a concrete finishing broom is a must, since it will give the newly patched driveway area a non-skid surface, which is essential to prevent problems while driving. Make sure to drag the finishing broom in a direction along the width of the driveway.
What causes asphalt to crumble?
There are several things that can lead to your asphalt driveway crumbling, such as: 1 Weather changes 2 Asphalt that is not sealed properly 3 Wear and tear
Why is asphalt weak?
Asphalt isn’t strong enough to withstand nature’s effects, mostly if the asphalt is laid in a state where it rains a lot, such as Washington and Oregon. The water will sink into the asphalt and freeze, which then causes it to crack. This makes the asphalt weak and prone to wear and tear over time.
What to do if your driveway is crumbling?
On the other hand, if your driveway is almost entirely crumbled, you will need to do a full re-pave to get the smoothness you want. If you are not sure that you will be able to do this job, or you don’t have the tools, you should consider consulting a specialist.
How long does it take for a tamper to cure?
Tamp it in as much as you can, then let it cure for 24 to 36 hours before you go any further. Once you’ve done all the fixes, you’re going to have to clean up the driveway. This starts by cleaning up your driveway once more. It may be monotonous, but you will need to clean up the driveway again.
How much does it cost to repair a driveway?
If you choose to hire a professional, getting your driveway repaired will typically cost between $850 to $3,100.This is about $6 to $10 per square foot, depending on what you’re patching up.
Can you fix cracks in asphalt?
Though the cracks, potholes, and dips can be aggravating, the truth is that they can be fixed relatively easily as long as you know what to do. With most minor cracks and straightforward issues, it’s possible to turn your asphalt repair into a DIY endeavor.
Can you do a DIY job on a crumbling driveway?
There are cracks and crumbles, and then there are driveways that are barely driveways anymore. If your driveway is just starting to crumble or has a couple of cracks, then you can do a DIY job without much issue.
What is Rapid Set Newcrete?
Specially formulated to restore lackluster concrete, resurfacing products like Rapid Set NewCrete ( available from The Home Depot) make it quick and easy for homeowners to address spalling on their own, without having to hire a contractor. The resurfacing material simply spreads over the existing, spalled concrete surface to create a fresh, flawless finish.
How to make pancake batter lump free?
Mix and apply the resurfacer. In a bucket, tub, or wheelbarrow, combine the resurfacer with water in the ratio recommended by the manufacturer. Then, using your drill-mounted paddle attachment, mix the two until you’ve achieved a lump-free consistency similar to that of pancake bat ter.
What causes concrete to spalt?
Over the course of a winter, or over the course of years, as the internal pressure rises and falls, it stresses the surface layer of the concrete, which leads to spalling. The fix typically involves nothing more than applying ...
Can you mist a driveway with resurfacer?
In especially dry, windy, or hot conditions, it may be necessary to mist the area while the resurfacer gains strength . But if you’ve chosen the right day for the project, you can apply resurfacer, drive off to do errands, and then return a little later and park your car on a pristine, perfectly smooth driveway.
Does Newcrete require primer?
NewCrete in particular stands out, because it simplifies and speeds up the process. For one thing, it rarely requires the use of primer.
