How do you fix a dishwasher that will not drain?
0:061:46How to Fix a Dishwasher That Won't Drain in 4 Steps - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst check that the drain hose is securely connected to the sink or garbage disposal. Use a rag toMoreFirst check that the drain hose is securely connected to the sink or garbage disposal. Use a rag to clear any dirt then tighten the clamp if necessary.
Why is the water in my dishwasher not draining?
It's likely the result of a full garbage disposal that won't allow the drain water to enter from the machine, so it backs up in the bottom of the dishwasher. Barring that, the problem is probably a kink in the drain hose, or a clog in the hose, the drain, or the air gap.
How do I force my dishwasher to drain?
How to Drain Your DishwasherStep 1: Prepare Your Dishwasher. ... Step 2: Make Sure Your Dishwasher is Turned Off. ... Step 3: Remove the Stagnant Water With a Towel. ... Step 4: Perform a Check On the Drain Hose. ... Step 5: Remove Drain Hose and Clean. ... Step 6: Check Dishwasher Drain.
Why is there standing water in the bottom of my dishwasher?
Water in the bottom of the dishwasher results from clogs in the filter, garbage disposal, drain hose, drain pump, or air gap. When food or sediment build up within these systems, the dishwasher won't drain properly. Locating the blockage and clearing the debris will solve the problem.
Why do I have standing water in my dishwasher?
Standing water in a dishwasher is usually caused by pieces of food getting clogged in the drain. It's important to clean your machine's drain and dispose of any food debris. Before cleaning out the screen, remove the bottom sprayer arm, rinse it, and set it aside.
How do I test my dishwasher drain pump?
0:402:24How to check the drain pump on your dishwasher ? - YouTubeYouTubeStart of suggested clipEnd of suggested clipUsing a screwdriver remove the dishwasher baseplate disconnect the anti flood switch connectors.MoreUsing a screwdriver remove the dishwasher baseplate disconnect the anti flood switch connectors. Step two tests the spare. Part set the panel aside and locate the motor.