how to repair drywall in shower

by Ryleigh Schowalter V Published 3 years ago Updated 2 years ago

^{How to Repair the Drywall in the Bathroom Above the Shower/Bathtub}

Remove Crumbling Drywall. Remove the softened, crumbling drywall and scrape away any peeling paint. ...
Attach Furring Strips. Attach at least one furring strip (1 x 3-inch piece of wood) to the back of the existing drywall with 1 5/8-inch drywall screws unless ...
Cut and Install Greenboard. Measure the hole and cut a piece of greenboard drywall to fit. ...
Apply Joint Compound. Apply a coat of joint compound to the edges of the patch using a 6-inch drywall knife. ...
Apply Additional Joint Compound. Apply two more coats of joint compound, allowing it to dry completely in between coats. ...

Prime the Patch. Prime the patch with drywall primer and sealer or a coat of latex (water-based) primer.

Apply Silicone Caulk. Apply paintable silicone caulk along the top lip of the shower or bathtub stall. ...

Dispose of Excess Drywall. Don't rinse large quantities of excess drywall down the drain because it can settle and clog the plumbing.

How to install drywall in your shower?

Prepare the Shower Area

Before attempting tub surround installation, check that your shower alcove is framed properly and in good condition. ...
Measure the width and depth of your alcove, and make sure the dimensions are correct for the shower you’re putting in.
Check the entire subfloor with a level. ...

More items...

How do you waterproof drywall in a shower?

– Paint them with waterproof paint, such as epoxy. – Cover them with a shower curtain liner. – Install a shower liner or surround kit. – Apply wall stickers that can be used in a high-humidity environment. – Attach beadboard panels painted with waterproof paint. What is waterproof wall board called?

How do you finish drywall around a shower surround?

Tools You Will Need to Complete the Job

Knives
Tapes
Level
Chalk line
T-square
Hammer
Drill
Pry bar
Screwdriver set
Safety eyewear

How to finish drywall around tub or shower surround?

Tools That You Will Need:

Screwdriver set.
Chalk Line.
Drill.
Hammer.
Level.
Pry Bar.
Safety glasses.
Ladder.
T-square.
Tapes.

More items...

How do you repair shower drywall?

How to Repair the Drywall in the Bathroom Above the Shower/...Step 1: Remove Crumbling Drywall. ... Step 2: Attach Furring Strips. ... Step 3: Cut and Install Greenboard. ... Step 4: Apply Joint Compound. ... Step 5: Apply Additional Joint Compound. ... Step 6: Prime the Patch. ... Step 7: Apply Silicone Caulk. ... Step 8: Dispose of Excess Drywall.

How do you fix drywall around a shower surround?

0:593:53Drywall gaps around tub and shower surrounds, How to fix them - YouTubeYouTubeStart of suggested clipEnd of suggested clipAround the surround make sure the heads of the screws are below the surface line of the drywall.MoreAround the surround make sure the heads of the screws are below the surface line of the drywall. Also make sure that the drywall. And the tub surround are secured to the frame wall.

How do you repair drywall around a bathtub?

4:147:17How to Waterproof Bathtub Drywall -- by Home Repair Tutor - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you have a tub surround like this one near the kerdi-band is pretty well adhere to the latexMoreIf you have a tub surround like this one near the kerdi-band is pretty well adhere to the latex paint in the part of the drywall that was damaged.

How do you fix water damaged shower walls?

Follow these steps to do so:Step 1: Remove the tiles from the affected area. ... Step 2: Remove the base or shoe trim. ... Step 3: Locate the next closet stud. ... Step 4: Cut out the damaged drywall. ... Step 5: Replace rotted studs. ... Step 6: Replace the removed drywall. ... Step 7: Fill in screw holes and seams.More items...

How do you fix water damaged drywall?

If drywall panels only show water stains but aren't structurally compromised, they may be repairable by cutting out the damaged portion. When cutting out around the damaged area, use a keyhole saw to cut the hole into a square or rectangular shape. You can then make a patch with another piece of drywall for the repair.

How do you waterproof a drywall shower?

It is possible to waterproof drywall in a shower by covering the drywall with a waterproof membrane. This waterproof membrane can be bonded to drywall with thinset adhesive to create a waterproof layer. Never tile directly over drywall in a shower.

Is there a special drywall mud for bathrooms?

Green. Green drywall is a type of drywall that's mold resistant and is used in applications where moisture can be an issue—so most commonly, bathrooms. To maximize the mold resistance, use mold-resistant drywall mud, aka joint compound. Green drywall generally costs about 20% more than regular drywall.

Is there waterproof spackle?

DAP 18741 Platinum Patch Filler This spackling dries to a waterproof solid and is compatible with various building materials, making it an excellent option for outdoor repairs. Whereas other exterior spackles require a coating of paint for protection, DAP Platinum is fully waterproof 24 hours after application.

Is drywall compound waterproof?

Setting-type joint compound dries hard, resists moisture and requires just a few coats to get the job done. Outdoor joint compound application is similar to indoor applications. But watch out for the weather. Avoid applying joint compound on humid, rainy days or when temperatures dip below 50 degrees Fahrenheit.

Is drywall ruined if it gets wet?

While drywall is pretty sturdy, when it's exposed to water for too long it can get damaged. It may lose its structural integrity, becoming soft and weak. Depending on what category of water drywall is exposed to, and how wet it got, you may be able to save it. Speed is critical to avoiding mold damage, though.

What happens if water gets under tile in shower?

However, water can also seep into the shower wall if there are missing tiles or grout. As the water seeps behind the wall, it can destroy the drywall, cause the tile to fall, and lead to mold. In some cases, water can even leak down and damage the ceiling on the floor below.

What happens if water gets behind tile in shower?

Moisture that gets behind tiles can cause all sorts of problems. It can destroy the drywall backing, it can cause rot, and it can cause the tiles to begin to fall off if left too long. Worst-case scenario, water damage behind your tiles can lead to mold problems.

Why does drywall soften?

If there's a lip at the top of the shower stall , water has a tendency to collect there and seep into the drywall, eventually causing it to soften ...

How long does it take for drywall to dry?

Embed fiberglass mesh drywall tape in the wet compound; then scrape off the excess and allow it to dry for at least eight hours.

Can you rinse drywall down the drain?

Don't rinse large quantities of excess drywall down the drain because it can settle and clog the plumbing. Instead, scrape the excess from your tools into a trash bag and dispose of it. It's OK to rinse the small amount remaining on your tools in a sink or tub.

How Do You Repair Water-Damaged Drywall Around The Shower?

Let’s get real here; you are only there to get the solutions to fix your wet drywall. I will take you through two simple methods that you can follow along very easily to fix your wet drywall.

How To Prevent Water Damage On The Wall Next To The Shower?

Yes, it’s great if you know how to solve a problem. But you know what’s better? It’s to prevent the problem from happening in the first place. And that’s what I am going to discuss right now.

Does Schulter Kerdi waterproof?

Certain waterproofing products (such as Schulter Kerdi) offer a warranty on their waterproofing capability even when drywall. is the substrate, but unless you have such a product, avoid putting drywall in direct proximity with the wet area of the tub or shower.

Can you use drywall to back up a shower?

It may seem obvious, but drywall should not be used to back the tile in the shower or bathtub enclosure, as sheetrock breaks down in the presence of moisture. Using drywall as a substrate for the tile is a recipe for potentially costly repairs (and probably after a relatively short time, too!).

Can you use shower bead to finish a gap?

The last possibility is to use a manufactured shower bead to finish the gap directly. Essentially, it is a pre-made product that allows you to split the difference between the first two methods. This plastic bead consists of support leg attached to a long mud leg, allowing you to attach them directly across the gap between the rock and ...

How to apply texture to a wall?

Apply the primer to the wall where you applied the new texture. Use a paintbrush to prime small areas or a small roller to prime medium size areas. Allow the primer to dry completely. Apply a second coat of primer and allow it to dry.

How to mix paint to match wall color?

Pour paint into a paint pan and apply it to the primed wall using a paintbrush or a small roller. Allow the paint to dry completely. Apply a second coat of paint and allow it to dry completely. av-override.

How to smooth out rough edges?

Put on a dust mask. Sand the area lightly to smooth rough edges where material was removed, using a fine-grit sanding pad. Brush the sanding dust off with a whisk broom.

Why does my bathroom wall peel?

By Mona Culberson. Hot, steamy showers can cause the drywall to start peeling from the bathroom walls if the room isn't adequately ventilated. When a tight budget doesn't allow the addition of more vents, leave the door open, or use a fan to keep the air circulating. You can do the repair yourself and save money.

Repairing Guides