How to Fix a Dripping Delta Shower Faucet
- Turn off Water to Your Shower. You cannot replace a shower cartridge with water already flowing in the pipes. ...
- Remove the Faucet Handle. A Delta shower faucet will have either a lever or a knob for a handle. ...
- Remove the Cartridge. Remove the trim sleeve. ...
- Clean the Shower Valve Body. ...
- Install the new Cartridge. ...
- Install the Handle. ...
Full Answer
How much does it cost to fix a leaking Delta shower faucet?
Fix a leaky Delta Single-handle shower faucet for UNDER $2!! - YouTube Fix a leaky Delta Single-handle shower faucet for UNDER $2!! If playback doesn't begin shortly, try restarting your device.
How do you remove a Delta shower faucet handle?
A Delta shower faucet will have either a lever or a knob for a handle. Removing any of them is however very easy. If you have a lever-type handle, turn it upside down to reveal a hex screw underneath it. Use an Allen wrench to remove the screw. Grab the lever and pull it out as you wiggle it at the same time.
How to fix a leaking shower faucet?
Turn on the shower faucet to drain the water already in the pipes. After draining the lines, plug off the shower or bathtub drain to prevent dropping anything down the drain.
How do you fix a leaky Aaron Stickley faucet?
Check for Leaking and Reinstall the Handle Aaron Stickley. Turn the water supply back on by opening the shutoff valve (under the sink) counterclockwise all the way until it stops. Check for leaking around the faucet stem. If it leaks, tighten the bonnet nut until the leaking stops; again, be careful not to overtighten.
How do you fix a leaking Delta single handle shower faucet?
1:054:13Repairing a leaky Delta bath or shower faucet-single lever and ...YouTubeStart of suggested clipEnd of suggested clipOn the top and the bottom there's two screwdriver slots just a matter of putting a commonMoreOn the top and the bottom there's two screwdriver slots just a matter of putting a common screwdriver in place going like so and there's your cartridge. Um delta go is good for their cartridge.
Why does my Delta shower faucet drip?
When you notice a leak around the nut area or at the base of the handle, there's a good chance that a loose nut is the reason why your shower faucet is dripping. The washer is worn out. The washer is not installed properly. The washer is not the right size.
What causes a single handle shower faucet to leak?
When water drips or drizzles from a shower head, there is a problem with the shower faucet (valve). In most cases, inner seals are worn, or parts have become corroded or clogged with hard water deposits. And the rubber O-rings and gaskets that seal connections between moving metal parts wear down with time and use.
How do you take apart a Delta shower faucet?
0:356:30How to Replace a Delta Faucet Shower Cartridge - YouTubeYouTubeStart of suggested clipEnd of suggested clipFor more information check the cartridge reference sheet in the instruction. Manual. Using an allenMoreFor more information check the cartridge reference sheet in the instruction. Manual. Using an allen wrench loosen. The set screw holding the handle in place. Now remove the handle.
How do you stop a dripping Delta faucet?
0:102:11How to fix a leaky dripping Delta faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd it could be that the nut that holds the valve down is a little loose. So it leaks just tightenMoreAnd it could be that the nut that holds the valve down is a little loose. So it leaks just tighten that and if the dripping stops then you're done you're good to go.
How do I identify my Delta shower cartridge?
The model number on the package by the UPC code or may be found on a supply line tag. We also have an online tool to help identify the model. The model number is on all packaging, some faucets, and all installation instructions provided with your faucet. On the packaging, look near the UPC code or the top of the box.
How do you fix a leaky single handle faucet?
0:182:44Repairing a Leaky Single Handle Ball-Type Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipFirst you will need to turn off the hot and cold water supply valve under the sink next. You willMoreFirst you will need to turn off the hot and cold water supply valve under the sink next. You will need to remove the single lever handle. This may require using an Allen wrench to loosen the handle.
How do you stop a Delta Monitor shower faucet from leaking?
3:128:48Cheap fix for a dripping Delta Monitor shower faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo I decided to get two new seals. Okay so to put these fittings back in those holes. I threadedMoreSo I decided to get two new seals. Okay so to put these fittings back in those holes. I threaded them on or stuffed it on this Phillips screwdriver and I'm just going to plug it back in that hole.
How do I know what shower cartridge I have?
1:323:16Who Made Your Shower Faucet? Tips to Find the Brand and ManufacturerYouTubeStart of suggested clipEnd of suggested clipOnce those screws are out you should be able to just pull this plate. Off and then you can lookMoreOnce those screws are out you should be able to just pull this plate. Off and then you can look behind the plate to see if there's a sticker in here that has the manufacturer.
How do you remove a Delta single lever shower handle?
1:568:22Fix leaky shower head with a stuck handle - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd then you can remove. This body and then you can remove the nut that's holding the cartridge toMoreAnd then you can remove. This body and then you can remove the nut that's holding the cartridge to the valve. And then you can do the seeds.
How do you repair a old Delta shower faucet?
0:5111:13How to Repair a Delta Tub / Shower Valve - YouTubeYouTubeStart of suggested clipEnd of suggested clipYou'll have to replace the kit this is what you'll need before you start the job the cam the bonnetMoreYou'll have to replace the kit this is what you'll need before you start the job the cam the bonnet gasket a ball.
How do you fix a leaky Delta 1700 shower faucet?
0:067:45Repair a Leaking Delta 1700 Shower Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipSeries faucet in our shower. And it's developed a little leak it's got a drip probably every 60MoreSeries faucet in our shower. And it's developed a little leak it's got a drip probably every 60 seconds to two minutes.
How do you stop a Delta Monitor shower faucet from leaking?
3:128:48Cheap fix for a dripping Delta Monitor shower faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo I decided to get two new seals. Okay so to put these fittings back in those holes. I threadedMoreSo I decided to get two new seals. Okay so to put these fittings back in those holes. I threaded them on or stuffed it on this Phillips screwdriver and I'm just going to plug it back in that hole.
How long should a shower cartridge last?
A good-quality shower faucet cartridge will last as long as 20 to 30 years. With regular maintenance, it can serve you for the foreseeable future. There are plenty of signs of a cartridge needing to be serviced or replaced.
How do you fix a leaky Delta 1700 shower faucet?
0:067:45Repair a Leaking Delta 1700 Shower Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipSeries faucet in our shower. And it's developed a little leak it's got a drip probably every 60MoreSeries faucet in our shower. And it's developed a little leak it's got a drip probably every 60 seconds to two minutes.
How do you fix a Delta 2 handle shower faucet?
0:226:52How to fix a leaking, dripping Delta bathtub faucet - $2 fix - YouTubeYouTubeStart of suggested clipEnd of suggested clipJust take the covers off of these handles. So just get a little knife here. And pop those off nextMoreJust take the covers off of these handles. So just get a little knife here. And pop those off next you can see those screws in there so we've got to take those out so we can take the handles. Off.
How Do You Fix a Leaky Delta Single Handle Shower Faucet?
Delta shower faucets are some of the most reliable and long-lasting in the industry. But they don’t last forever. At some point in their life they will start to leak.
1. Turn off Water to Your Shower
You cannot replace a shower cartridge with water already flowing in the pipes. Those who have attempted it have a story to tell.
2. Remove the Faucet Handle
A Delta shower faucet will have either a lever or a knob for a handle. Removing any of them is however very easy.
3. Remove the Cartridge
Remove the trim sleeve. This is the round piece between the handle and the cartridge. It is usually not threaded so you only need to slide it out. You will see a spacer when you look inside the trim sleeve. Put the sleeve aside.
4. Clean the Shower Valve Body
Grab a flashlight and inspect the inside of the shower valve body. Check if there is corrosion, mineral deposits or just any form of debris that will prevent you new cartridge from working properly.
5. Install the new Cartridge
Apply grease on the new cartridge’s O-rings. This helps it to seal effectively and also easy to pull out the next time you will be replacing it.
6. Install the Handle
Install the faucet handle back pretty much the same way you removed it.
What is a delta faucet?
Delta bathroom and kitchen faucets with two handles often are stem-style faucets that include a neoprene valve seat and spring that fits into the faucet below a cartridge-like insert stem. This is different from a true cartridge-style faucet, which closely resembles a stem faucet but does not have valve seats and springs.
How to tell if a faucet is leaking?
Determine Which Side Is Leaking. Place your hand under the drip from the faucet. If the water is warm, the leak is most likely on the hot side of the faucet. If the water is cold, the leak is most likely on the cold side. This tells you which is the better side to fix first, but it's possible that both sides are leaking in any case.
What is a stem style faucet?
With a stem-style faucet, a neoprone valve seat and spring fits into the water inlet port in valve body. Over the valve seat and spring, the stem is held into the body with a bonnet nut; the handle then fits onto the top of the stem. Leaks in this type of faucet usually can be fixed with a new neoprene valve seat and spring.
How to remove valve seat and spring?
Remove the seat and spring by inserting a small screwdriver or Allen wrench into the hole of the seat and pulling up both parts together. Note the spring's orientation inside the valve seat. The spring should be slightly larger in diameter at the bottom than at the top—where it fits into the seat.
How to replace a valve stem?
If desired, you can also replace the O-ring (which is sometimes included with stem-and-spring kits) or the entire stem. Fit the stem into its housing, aligning the tabs on the stem with the slots in the housing. Push the stem all the way down until it stops.
How do I shut off the water in my kitchen sink?
The valve may have a small football-shaped handle or a lever or knob. Turn the handle clockwise until it stops. Open the hot or cold faucet, as appropriate , to make sure the water is off.
Where is the valve seat on a faucet?
Look inside the stem housing and locate the neoprene valve seat sitting in a hole at the bottom of the faucet housing. The valve seat is a small, black, rubber cap with a hole in the top. Sitting inside and below the seat is a small metal spring.
