
Moen Bathroom Faucet Leaking Repair
- Step 1: Switch off the Main Lever. First of all, you have to go through the main switch of the water. The main switch is...
- Step 2: Opening the Faucet. Here, opening the faucet refers to opening the handle. So you already know which side of the...
- Step 3: Put off the Cartridge. If you want to go for a Moen faucet repair bathroom sink,...
Full Answer
How to fix a leaking Moen 7800 faucet?
Tightening the Handle of a Loose Moen Kitchen Faucet
- Turn the Water Supply Lines Off. When you tighten the handle on your Moen kitchen faucets, you will first have to clean the top of your sink area.
- Check the Handle on Your Kitchen Faucet. Each Moen kitchen faucet has a certain setup. ...
- Remove the Hex Nut or Plastic Screw. ...
- Find the Setscrew. ...
- Tighten the Setscrew. ...
How to repair a leaking Kohler shower faucet?
- Water Flows From Showerhead & Tub Spout Simultaneously. Please review the "Important Information" notes of the installation instructions. ...
- No Water Output. Rite-Temp valves feature a pressure-balancing unit (PBU). ...
- Hot Water First. ...
- Water Temperature Fluctuations. ...
- Delayed Flow. ...
- Leak After New Service Kit Installed. ...
- Springs Fell Out of Cap Assembly. ...
How do you remove Moen shower faucet?
Push the screwdriver upwards to while pulling the fixture post (#1) forwards to remove it from the wall. The opening on the fixture post (#1) must face down to line up with the locking tab. Press firmly on the fixture post (#1) until it clicks.
How to replace washers in a Moen kitchen faucet?
Preparation:
- The water supply shut off valves must be turned off- see article How to Turn Off the Water Supply to the Faucet.
- Recommended Tools: Needle-Nose Pliers
- The following instructions assume the handle and associated handle pieces have been removed. For additional details, visit solutions.moen.com and select the type of faucet you are repairing. ...

How do I stop my Moen shower from dripping?
0:2810:07How to fix a leaking Moen Shower - YouTubeYouTubeStart of suggested clipEnd of suggested clipStep is you're going to verify that the water is in fact off by turning the handle. And this alsoMoreStep is you're going to verify that the water is in fact off by turning the handle. And this also will drain out any excess water that's inside the valve.
How do you fix a Moen single handle shower faucet?
0:269:09How to Repair a Moen Shower Faucet Step-by-Step - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd I'm going to show you how easy it is to install it these are for single handle faucets. And youMoreAnd I'm going to show you how easy it is to install it these are for single handle faucets. And you can pick these up at a home depot or any other hardware store like that.
How do you replace a Moen shower faucet gasket?
4:2310:41How to Repair a Leaky Moen Tub / Shower in 30 Minutes - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf your cartridge. Didn't slide out quite that easily I'm going to show you a tool that you can useMoreIf your cartridge. Didn't slide out quite that easily I'm going to show you a tool that you can use that's pretty inexpensive. That will help you actually do that work for you.
Why is my shower still dripping water when everything is turned off?
If the cartridge becomes worn or cracked, water can seep through—even when the handle is in the “off” position. This can cause water to drip or trickle from the shower head. Here, too, replacing the worn cartridge requires turning off the water supply to the shower.
How do you fix a leaky single handle shower faucet?
0:172:38Repairing a Leaky Single Handle Tub/Shower Ball-Type FaucetYouTubeStart of suggested clipEnd of suggested clipTurn off the main water supply to your home. For an obstacle remove the index button by prying offMoreTurn off the main water supply to your home. For an obstacle remove the index button by prying off with the screwdriver. Then unscrew the handle screw. And remove the handle.
How do I know what Moen shower valve I have?
If not the series number can be usually be found on the underside of the faucet or on the decorative escutcheon ring that goes around it. The second way to identify your Moen valve cartridge is to remove the old one. You will do this by first shutting off the hot and cold water feed to your shower.
How do you know which Moen cartridge you need?
0:063:58Old plumber shows tips and tricks on moen faucets. Choosing the right ...YouTubeStart of suggested clipEnd of suggested clipSimply by going to your faucet years ago go into your faucet. And pull them pulling. On yourMoreSimply by going to your faucet years ago go into your faucet. And pull them pulling. On your cartridge if the handle pulls out it's a 12 25 cartridge.
How do you remove a cartridge from a Moen faucet?
0:162:05How to remove and install the Moen 1224 Cartridge - YouTubeYouTubeStart of suggested clipEnd of suggested clipStep 2 remove the trim and the 1224 cartridge unthread the set screw to detach the handle. RemoveMoreStep 2 remove the trim and the 1224 cartridge unthread the set screw to detach the handle. Remove the cartridge nut. Pull out the cartridge.
How do you replace a old Moen shower cartridge?
1:133:14How to Remove & Install the 1222 Cartridge - YouTubeYouTubeStart of suggested clipEnd of suggested clipMake sure the cartridge is in the on position the notch in the stem should be facing up remove theMoreMake sure the cartridge is in the on position the notch in the stem should be facing up remove the cartridge from the valve. You can also use the Moen cartridge removal tool to pull out the cartridge.
Why does my shower head drip hours after I turn it off?
More often than not, a dripping showerhead is the result of worn or damaged inner seals. The rubber washers or O-rings in your shower act as a seal between your showerhead and shower hose, preventing water from leaking out. Over time, these wear down, and when they do, water starts to leak out.
How do you fix a shower faucet that leaks water?
2:396:24Fix Tub Spout That Leaks Water When Shower Is On - YouTubeYouTubeStart of suggested clipEnd of suggested clipNow what's happening is there's probably some mineral deposits stuck down within the spout itselfMoreNow what's happening is there's probably some mineral deposits stuck down within the spout itself which is allowing that to stay partially. Open.
Do you need to turn off main water to change shower head?
There's no need to turn off the water to the house. Unscrew the old showerhead by twisting it by hand in a counterclockwise direction. Most heads aren't screwed into place, but if yours is, remove the screws first. If it's tough to remove because it's old and corroded into place, you might need to use a wrench.
How do you fix a shower diverter pull up?
0:096:11Tub faucet spout diverter pull lever broke off - DIY fix - YouTubeYouTubeStart of suggested clipEnd of suggested clipAround the actual medium point of your spout. And the shower wall just carefully grab a utilityMoreAround the actual medium point of your spout. And the shower wall just carefully grab a utility knife and remove. It. And again in our case we just got this rubber seal you can purchase.
How do you take apart a single handle faucet?
0:182:44Repairing a Leaky Single Handle Ball-Type Faucet - YouTubeYouTubeStart of suggested clipEnd of suggested clipThis may require using an Allen wrench to loosen the handle. There may be a button that covers theMoreThis may require using an Allen wrench to loosen the handle. There may be a button that covers the screw that needs to be removed first and then you can loosen the screw and remove the lever handle.
How do you disassemble a Moen adjustable shower head?
1:056:21How to Disassemble and Clean a Moen Shower Head - YouTubeYouTubeStart of suggested clipEnd of suggested clipSimple this piece comes out through the back you got to pop that off it's fairly simple i just pushMoreSimple this piece comes out through the back you got to pop that off it's fairly simple i just push it flat against the counter.
How do you take apart a Moen faucet?
Some Moen faucets have handles that remove by loosening the screw in the back of the handle. To loosen this screw use a 3/32" hex wrench. After the handle has been removed unscrew the spout collar nut by turning counterclockwise then lift and rotate the spout.
1. Turn off the Water
You cannot repair a shower faucet when there is full water pressure in the pipes. The first to do therefore is to turn off water supply to the shower (and possibly the entire house) and drain that which is already in the pipes.
2. Remove the Faucet Handle
The faucet handle is attached to the cartridge using a screw on its underside. To access the cartridge you will first need to remove the handle. While most Moen handles will look this way, there also other variations. One way or the other the handle will have a screw somewhere.
3. Remove the Old Faucet Cartridge
Once the faucet handle is out, you will see a plastic holder (usually black) connected to the cartridge using a Philips screw. Remove the handle holder using the Philips screwdriver.
4. Install the New Cartridge
Prior to installing the new cartridge, it is a good practice to first clean the valve. Use an old toothbrush, to scrub off calcium and other mineral deposits. If there are lots of debris inside the valve, turn on the water slowly to flush out the debris. This will prevent leaking from the new cartridge.
5. Test the New Moen Shower Cartridge
Turn on the water supply to the shower and check for leaks when the faucet is turned off. Open the water and let it run and then turn it off. Check if the faucet is shutting off precisely.
