Repairing Guides

how to repair loose charging port

by Casimer Grant Published 2 years ago Updated 2 years ago
image

How to Fix a Loose Charging Port

  • Try out a different power source.. You can use a charging dock or power bank like this one. If nothing else works, then...
  • Attempt charging from a different power source.. Gently push down on the charging port as you insert your cable into it.
  • Check the charger adapter for damage.. If it is broken or damaged, replace it with a new one.

Full Answer

What do you do when your charger port is loose?

  • Remove the back cover, SIM card and microSD card
  • Remove the battery
  • Unscrew the midframe and disconnect various cables and screws

How much does it cost to replace charging port?

You can either fix the power jack or replace the entire motherboard, which is a very expensive option. At the end of the day, it is cheaper and easier to replace the charging port because the entire process, including the labor, is unlikely to cost you more than $150.

How to get a loose micro USB port working again?

USB Port Not Working FAQ

  • Restart the computer.
  • Inspect the USB port.
  • Try another USB port to see whether it is a USB drive issue.
  • Use a different USB cable.
  • Check the USB controller.
  • Upgrade the device driver.

How do I replace the charging port?

  • Use canned air to blow into the port
  • Use a cotton swab to gently pull dust out of the port
  • Use a needle wrapped with double-sided tape to clear debris from the port If cleaning your charging port doesn’t help, you might have to replace your Motorola Moto X charging ...
  • Pry tool
  • Hair dryer (optional)
  • Torx T4 screwdriver

More items...

image

What do I do if my charging port is loose?

3:015:57HOW TO FIX ANDROID PHONE Loose CHARGING PORT At HOME ...YouTubeStart of suggested clipEnd of suggested clipAs you see now it's tight. It's not a loose port. Next we're going to clean this port using someMoreAs you see now it's tight. It's not a loose port. Next we're going to clean this port using some isopropan alcohol and a brush because there is lot of dust.

Can you tighten a charging port?

0:112:31How to Fix a Loose USB Cable / Phone Charger Port - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd this little tip is just about how to get the charging port on your smart phone to be a bitMoreAnd this little tip is just about how to get the charging port on your smart phone to be a bit tighter you might notice over time that it doesn't quite go all the way in anymore.

How much does it cost to fix a loose charging port?

Expect to pay between $2 and $30 for a new charging port, depending on the model and whether you buy a standalone charging port or a flex cable/assembly (more on that below). Toolkits start at $5 if you don't already have the tools you need.

Why is my phone's charging port so loose?

Maybe it feels a little loose, or wobbles back and forth. Or sometimes when it starts charging, it will stop if you bump it, or even randomly stop charging altogether. Annoying isn't it? Well, typically the culprit is just pocket lint clogging your charge port and you can easily fix this problem in just 3 easy steps.

Why do chargers wiggle?

There's dirt, pocket lint or other cruft in the connector on the phone that prevents the cable from seating properly. This is the "good news" answer; if you clean out the connector with a bright light and a non-metallic probe (such as a toothpick) it should resolve the problem.

How can I charge my phone if the charger port is not working?

1:082:36How to charge any phone with a broken usb port. - YouTubeYouTubeStart of suggested clipEnd of suggested clipOn some phones there are only two pins or three pins. So what you do is gonna shape these as youMoreOn some phones there are only two pins or three pins. So what you do is gonna shape these as you like. So they are the best fit for your phone. You. Put them inside the phone make sure they connect.

Can phone charging ports be fixed?

Fixing a charging port on your own can be challenging Using an incorrect tool or not knowing how to fix the device can damage it permanently. But you can trust the technicians at Phone Clinic to ensure that your iPhone or Android mobile phone is fixed correctly the first time.

How can I fix my Android charging port?

Emergency fixes for a broken charging portTurn off your device.If possible, remove the battery.Get a small stick to rearrange any misplaced tabs inside the USB port of your phone.If the charging pin is misaligned, lever it up slowly and gently.Reinsert the battery.Plug in the charger.

How do I know if my charger port is damaged?

Remove the charging cord and check the connecting port for a burning smell or signs of oxidation, both of which can indicate a problem. If the connector feels loose, this may also suggest an issue with the power adaptor block.

Why does my phone only charge at an angle?

Why your Apple device charges at an angle. The most common reason why this is going to happen is that the charging port inside your iPhone or Pad is dirty this can be due to dirt or pocket lint filling up the charging port ensuring the charger cannot establish a proper connection.

How can I charge my phone if the charger port is not working?

1:082:36How to charge any phone with a broken usb port. - YouTubeYouTubeStart of suggested clipEnd of suggested clipOn some phones there are only two pins or three pins. So what you do is gonna shape these as youMoreOn some phones there are only two pins or three pins. So what you do is gonna shape these as you like. So they are the best fit for your phone. You. Put them inside the phone make sure they connect.

What to do if your laptop charger is not working?

If your laptop charger not working,you must replace or repair the charger to continue use your laptop.

Why does my laptop keep charging when it's broken?

In fact, the reason for this is the long-term accumulation of dust and fluff in your pocket.

What happens if my laptop power outlet is loose?

If the laptop power outlet is loose,the laptop's charging port must be repaired. There may be a problem with the laptop power socket. Check if the metal tentacles are deformed or broken. If the charging port of the motherboard is open, then it can be used normally after disassembling and then welding.

What to do if power jack is loose?

If the power jack is loose,solder some connections and reconnect it to the motherboard.

Can a laptop be charged after cleaning?

Finally, after the charging interface is cleaned up, the laptop can be charged normally.

Is it normal for a notebook to have loose charging plugs?

Contact the official after-sales service if it is faulty. Some notebooks tell you that this is normal. Charging plugs generally have a certain range of looseness. But conventionally, this comes from the motherboard flexing, as the cable is connected to the corner of the MB. It shouldn't be a problem, but if you continue to wiggle it over time it could bend the MB and sever a connection. Typically, this isn't a defect,mostly it comes on low end devices with poor internal Mobo support.

Step 1

First, you will need something small and pointy, like a toothpick. We don’t recommend using a needle because it may actually be too sharp and damage your phone. If you have some canned air, that will come in handy too.

step 2

Gently insert the toothpick all the way into the charge port and see if you can feel any debris. Be careful to not scratch the sides of the charge port too hard. Depending on your model of phone, there could be delicate pins on the side that you could damage.

step 3

Once you feel like it is loosened up, try and scoop it out and use the canned air to blow any remaining debris out. If you don’t have canned air, you can blow it out with your mouth (just try not to spit all over it).

How to fix a loose charger port?

2. Use a magnetic charging cable fix loose charger port, which is the most thorough solution. You can only avoid hardware wear, and the data transmission and charging efficiency are the same as the original cable.

How to fix a charger that is loose?

To fix a charger that is loose or has a short, simply squeeze the end with a pair of pliers. Do not squeeze the end too hard. The end you want to squeeze is the end that you are having the problems with. You do not have to squeeze anything in your phone or take your phone apart at all.

How to attach a charger cord to a cell phone?

Attach to the back bottom of the cell phone (or side, if that is the location of your port). The sticky part will be face up. Insert your loose charger cord, laying it down on the sticky tape. The sticky duct tape will hold it securely. When complete, fold the duct tape for later use. I leave my tape on the phone.

How to fix a charger that wears down the phone?

The charger sometime wears down the edges of the phone and theirs many easy solutions to this problem by using a tool to add a bit of material around the port to create a holder for the socket. I do it another way and it's a quick fix not something you should do long time. I grab a small piece of foil and fold it flat enough for it to fit in the port with the Charger and it holds it in place perfectly with no problems whatsoever really.

What to do if a new cable doesn't work?

If a new cable doesn't help, you may have to replace the charging port. Take a look at the teardown and see if that is something you are comfortable with. you will have to solder a new connector to the board. The port is available at places like this. Hope this helps, good luck.

Can you replace a USB port that is loose?

Really when it begins to be loose there is not much you can do except replace it . Sooner or later it will get worse and your USB port will be completely useless, so its better to just replace it like they said. I think the manufacture wants them to break because they often don't have much solder holding them in place. You can be sure to solder it on securely if you do it yourself and you can even add a little epoxy to make sure it stays in place a lot longer this time.

How much does it cost to replace a Samsung charging port?

Expect to pay between $50 and $90 for professional Samsung charging port replacement, depending on your model and selected service. It’s a good idea to see if your repair shop offers any warranties on parts and labor. You should also inquire about your service tech’s experience, credentials and part quality.

How much does it cost to get a new charging port?

Expect to pay between $2 and $30 for a new charging port, depending on the model and whether you buy a standalone charging port or a flex cable/assembly (more on that below). Toolkits start at $5 if you don’t already have the tools you need.

How to remove lint from Samsung phone?

Follow these steps to remove lint and repair the USB charging port on your Samsung phone. Insert a small needle into the charging port and slowly, gently swipe it through the space between the contacts and the USB port walls. As you swipe, gently pull the needle toward you and out of the port to remove lint.

How to replace a cracked Samsung phone screen?

On older models like the Samsung Galaxy S1 through S5, Galaxy J1 through J3 and Galaxy Note 1 through Note 4, you’ll generally need to do the following to access the charging port: Remove the back cover, SIM card and microSD card. Remove the battery.

What to do if playback doesn't begin?

If playback doesn't begin shortly, try restarting your device.

Is the charging port a part of the cable?

On newer models, the charging port is sold either as a standalone part or as part of a flex cable (also known as an assembly or, in some cases, a daughterboard).

Do charging port repairs include premiums?

Here are example charging port repair deductibles, which vary depending on your model and plan. Note that these prices do not include premiums. You can click the links to start a claim.

How to keep USB port from getting loose?

Use protective gear while riding a bike or driving a car to avoid jerks on the device , which can make your micro USB port loose.

Why is my micro USB port loose?

The cause of loose micro-USB ports is many. It can happen due to lack of care while charging, over usage, or just because of normal wear and tear.

How to clean USB port?

You can also apply a bit of rubbing alcohol to a cotton swab or a dry cloth and clean the inside of the port where you’ll be inserting the micro USB cable.

What glue to use to hold a port?

Epoxy glue can be used as a temporary solution to hold your port steady until you have time to fix the problem permanently.

How to unplug USB cable?

Always unplug your USB cable by holding the connector. Never pull out the cable using the cord.

What is a micro USB port?

Micro USB ports are one of the most common ports on smartphones and tablets. It is used to charge your device, transfer data such as pictures and music, and many other functions. If this port gets loose, then it will give you a lot of problems.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9