how to repair outdoor wicker furniture

How to Repair Your Resin Wicker Outdoor Furniture.

• Step 1 - Determine the Full Extent of Damage. Browse affordable wicker furniture on Amazon.
• Step 2 - Clean the Chair.
• Step 3 - Use a Resin Epoxy to Re-glue the Loose Wicker Strips.
• Step 4 - Buy New Resin Strips and Reweave Them.
• Step 5 - Paint if Necessary.

Full Answer

How to buy and restore wicker furniture?

Repair and prime. Once your wicker furniture is clean and dry, the next step is to prep it for a paint job. Carefully inspect the item for damaged reeds, and glue any broken pieces back into place with wood glue and let it dry. After you've completed any repairs, Henry says to apply an oil-based primer using a natural bristle brush.

How to repair, paint, and restore wicker furniture?

Materials

• liquid detergent
• hot glue
• spray paint

How to properly store wicker furniture in the winter?

Where to store patio furniture in the winter?

• Just remember the 3 C’s: clean, coat, & cover.
• Clean It Up. You have to clean your furniture whether you need to store it inside or leave it out in the patio. ...
• Coat the Surface. There are furniture materials that need a bit of coating before you store them. ...
• Cover with Breathable Material. Lastly, find a perfect cover for your furniture. ...

Can wicker furniture be left outside in winter?

Wicker furniture is characterized by its woven design, which is highly susceptible to weather changes. Expanding freezing water can cause cracks and lead to rot. If your wicker furniture has not been specifically treated to be outdoors or made with weather-safe material (such as rattan), store it inside during the winter.

Can wicker patio furniture be fixed?

Wicker furniture can get damaged over time, but you can easily repair it with some wood glue and loose reeds. If you have loose ends on your wicker furniture, first, apply a drop or 2 of wood glue to the bottom of the reeds.

Can you repair wicker furniture?

You fix it of course! Repairing wicker furniture is actually quite easy and doesn't take much time at all. In this guide you'll find easy tips, tools and tricks on repairing everything from your wicker table and chairs, to your sofa and other wicker furniture accessories.

How do you fix sun damaged wicker?

When wicker with a clear finish (lacquer, shellac or varnish) becomes dull, you can usually restore its luster by rubbing with a soft cloth dampened with furniture polish or lemon oil. Minor scratches can be disguised by rubbing with a wax-stick scratch remover, available at home centers and some furniture stores.

How do you fix unraveling resin wicker?

If the resin strips are loose, you can reattach them with glue. You can use resin epoxy. Dip the tip of the strip in the epoxy and hold it in the weave for a few seconds. If the strips are cut or frayed, you will need to repair them differently.

How do you glue wicker furniture?

Spread a generous amount of wood glue onto the areas where the wicker will be reattached. Use an invisible or clear type of glue. On twisted areas, untwist the wicker slightly so that the glue penetrates between the twisted strands.

Can resin wicker be repaired?

If the resin strips in your faux wicker patio furniture are frayed, worn or cut, you can replace or repair them without too much effort or expense – and get a few more years out of the set. Check with the manufacturer for matching spare strips.

How do you bring wicker back to life?

How to Refresh Dried-Out WickerVacuum the wicker thoroughly using a bristle attachment. ... Mix water with a mild detergent. ... Mix 1/4 cup of bleach in 4 cups of water. ... Place the furniture in a well-ventilated area, preferably outdoors on a sunny, breezy day.More items...

What is the best paint for wicker?

Which paints are best for painting wicker furniture? You can use chalk paint, mineral paint, milk paint, urethane, or even oil-based paint on wicker, rattan and woven furniture.

Can u spray paint wicker furniture?

The key is to thoroughly clean wicker furniture before you begin painting to ensure the new color adheres properly. Spray paint is the best way to paint wicker furniture for a consistent finish, but this project can get messy.

What is resin wicker made of?

Resin wicker is made from extracted resins that come from plant material, as well as synthetic fibers. The materials are then hardened permanently. There are various types of these wickers available, including PVC, nylon, high-density polyethylene and polyethylene (PE).

Can rattan furniture be repaired?

Not to worry—both wooden and synthetic rattan are easy to repair, and both can be fixed in the same way. If your furniture only has a few loose ends or wrappings, refer to the first method in this guide. If some sections of your furniture need a little extra TLC, skip ahead to the second method.

How do you fix a rattan wrap?

Add a dab of wood glue under the old wrapping and glue it down. Slip the new wrapping under the glued piece and secure it with a small tack. Now, wrap the flexible new cane around the leg until the damaged area is covered.

Step 1 - Determine The Full Extent of Damage

Check the piece of wicker furniture over carefully to see if the frame is damaged as well as the wicker weaving. If there is no frame damage, proce...

Step 2 - Clean The Chair

Glue will adhere best to a material that is free of dust and debris, so be sure to thoroughly clean your furniture before you conduct repairs. Rins...

Step 3 - Use A Resin Epoxy to Re-Glue The Loose Wicker Strips

You can re-glue the resin strips if they were just pulled loose from the weave. Obtain resin epoxy at a building supply center. If you're unsure ab...

Step 4 - Buy New Resin Strips and Reweave Them

If the strips are shredded, broken, or frayed, you will need new resin strips to replace them. Try to first obtain these from the manufacturer so t...

Step 5 - Paint If Necessary

Once the epoxy has had ample time to cure, you can go through and use paint to retouch your wicker. This will only be needed if the resin strips yo...

How to fix wicker furniture that is damaged?

2. Soak replacement reeds in warm water for 30 minutes to make them flexible. Select the replacement reeds you need to fix your damaged wicker furniture. Place them in a large container full of warm water. Let them sit in the water for 30 minutes.

How to get loose ends out of wicker furniture?

1. Scan the furniture for loose ends. Examine your wicker furniture to spot any pieces poking out. Do this in a well-lit area, or use a map lamp or flashlight to see things clearly. Use your hands to feel for loose ends in place that you may not be able to examine easily close up.

How long does it take for wicker to dry?

Avoid touching the furniture for 30 minutes so the glue can fully dry. If you have a section on your wicker that’s broken, first, use an Exacto knife to cut out the damaged strands. Then, soak replacement reeds in warm water for 30 minutes to make them flexible.

How to attach wicker to a chair?

Apply a drop or 2 of wood glue to the bottom of any loose ends that are sticking out. Carefully tuck them back into the wicker pattern by pulling the strands together. Hold down the glued pieces for several seconds to allow them to bond to the chair. Do this for each loose strand you find.

How to replace reeds in wicker?

Weave the replacement reeds into the wicker furniture. Thread a replacement reed into the furniture, starting from a point near the back that is less visible. Using pliers or your fingers, gently weave the reed in an out of the wicker. Follow the pattern of the wicker for the best results.

How to clean a reed from a reed?

Remove excess water from the reeds. Remove the reeds from the water and place them on a pile of clean paper towels. Gently press on the reeds with another paper towel to drain out excess water. Continue pressing on them with fresh paper towels until no more water comes out.

How to spray resin on wicker furniture?

Place the wicker furniture outdoors or in a well-ventilated area. Spray a thin layer of resin-based primer over the entire surface of your wicker furniture. Let it dry for 2-3 hours. Hold the can 2–3 inches (5.1–7.6 cm) away from the furniture when spraying it. Wear a mask to avoid inhaling fumes.

How to fix a crack in wicker?

Cracks in wicker furniture are not terribly uncommon, and the culprit usually is excessive dryness. The remedy is moisture. Rehydrate the damaged wicker with boiled linseed oil. It is important to note that because linseed oil is very flammable, purchase it packaged as being already boiled and never attempt to boil it yourself. Apply the boiled linseed oil to the cracked wicker with a brush in a well-ventilated area , paying particular attention to all of the crevices of the furniture. Keep applying the oil until the wicker no longer absorbs it. Remove excess oil with a clean towel and allow the furniture to dry for at least 24 hours.

How to repair wicker strands?

If your wicker furniture requires the replacement of a strand, the repair can be done at home. Soak the replacement wicker fiber in water for 30 minutes. This makes it easier to bend and weave through the furniture’s frame. Cut each end of the broken reed to remove it from the furniture.

How to fix wicker ends that curl?

The key to successfully correcting ends or pieces of wicker that come loose and start to curl is to work with wet reeds; this aids in manipulating the wicker back in place. To get the wicker to this point, cover the reeds in need of repair with wet towels for 30 to 60 minutes. If you find that after this time the wicker still resists movement, don’t force it. Soak it again until the reed easily moves to the position you want. Once in place, tuck the end back into the furniture’s frame and hold it in place with tacks as a temporary solution. After the wicker has dried, apply a small amount of wood glue onto the end and hold it into place with your fingers or tacks until the glue dries, too.

Is wicker furniture durable?

Wicker, while mostly durable, has certain characteristics that make it susceptible to damage. This is especially true during times of rain and heat when bouts of moisture and the subsequent dryness that follows have unfavorable effects on the furniture. From cracked reeds to ends that have frayed or curled, these imperfections are relatively easy ...

How Can I Repair a Resin Wicker?

To repair your resin wicker furniture, you will need a few tools. You will need new resin wicker strips, manicure scissors or box cutter, and plastic epoxy. Optionally, you will want to match the wicker color with matching paint or spray paint.

Why is plastic wicker furniture durable?

Plastic wicker furniture lasts for a long time because they are durable and weather resistant. If you clean the furniture regularly, it will give you a nice look that outlasts regular wicker furniture. Another benefit is that it is lightweight, making the furniture, like plastic rattan tables and chairs, easy to move.

How to epoxy a weave?

With the help of a paintbrush, apply the epoxy in the empty space and insert the new strip in the weave. Lastly, connect the strips to the epoxy.

What to do if resin strips are loose?

If the resin strips are loose, you can reattach them with glue. You can use resin epoxy.

How to match furniture color?

Try to match your furniture’s color or you will have to do a touchup with matching paint. Then, you will need a pair of needle-nose pliers. For the finishing touch, you will need a paintbrush and a similar colored paint. Spray paint will also do the job to match your color or redo the color of your furniture.

What are the benefits of rattan furniture?

Another benefit is that it is lightweight, making the furniture, like plastic rattan tables and chairs, easy to move.

Why use a weave puller?

The reason to use these tools is to pull the strips that are damaged from the weave.

How to fix wicker furniture that is cracking?

To do this, apply tung oil or boiled linseed oil with a brush and let it dry for at least 24 hours. Make sure that the oil is fully absorb ed by the reed. This will replenish and harden the material used for your furniture. If there is excess, wipe it off and wait for the furniture to dry completely. Just take note that linseed oil and tung oil are combustible so keep it and any material you soaked with it away from heat.

Can you spray paint wicker furniture?

After repairing your wicker furniture, always spray-paint the areas you repaired so that it matches the whole piece. If the furniture is used outdoors, it is best to use an exterior-enamel spray so that it won’t break easily. For more information about refinishing wicker furniture please visit our earlier blog post.

How To Repair Wicker Furniture: Reed Replacement for Missing or Damaged Wicker Furniture

Repairing wicker furniture seems difficult, and in some situations it is. This course, on the other hand, focuses on repairing lost or broken reed that is weaved in one direction and is not designed for very complex woven portions. Small repairs are simple, and performing them yourself may be a satisfying experience.

10-Step Procedure for Replacing a Missing or Damaged Reed

The first step in how to repair wicker furniture is to examine the damage that has to be repaired, and determine whether re-weaving would suffice. Determine the extent of the damaged or missing wicker reed if it is easily visible. You should have a clear idea of what repairs are required.

Summary For How To Repair Wicker Furniture

After replacing each broken or missing reed, the weaving should be tight but not too slack. It is sometimes unavoidable to have a loose weave in a repair, although it is far preferable to be loose than damaged or absent.

How to get a broken resin strip out of a weave?

Cut off a broken, jagged or frayed end of a resin strip with a box cutter or sharp manicure scissors -- useful for getting into a tightly woven spot. Pull the damaged strip out of the weave.

How to attach a new strip to a piece of fabric?

Glue the ends of the new strip in place with more epoxy. Trim them to connect with the existing strips, if possible. Or tuck the raw ends in and under the weave so they are not visible from the front of the piece and secure them with epoxy.

Can you wrap faux wicker patio furniture?

Keep your faux wicker patio furniture under wraps in harsh winter climates to prolong its life.

Can you replace resin strips on wicker patio furniture?

If the resin strips in your faux wicker patio furniture are frayed, worn or cut, you can replace or repair them without too much effort or expense -- and get a few more years out of the set. Check with the manufacturer for matching spare strips. If those aren't available, you may have to paint the finished piece or touch up an undetectable area ...