With the cooler open, spread it evenly along the teeth and both sides of the seals (inside and outside). Use your finger to spread it evenly. 2. Spray silicon lube on a cloth and wipe the zipper (again, with the cooler open so you can do both sides. Wipe it several times with the cloth almost wet with silicon lube.
Is the RTIC zipper supposed to be this hard to unzip?
After a couple of years the brothers RTIC zipper is still tough to unzip. Works well as a boat cooler though I got an RTIC for Xmas and that is my one complaint with it. Hoping that it loosens with use but not counting on it. Many of the soft sides have that have the waterproof zipper are this way from what I have seen.
How do you Lube the zipper on a cooler?
The zipper lube is not vaseline. It’s silicon mixed with wax. Use it, it works. With the cooler open, spread it evenly along the teeth and both sides of the seals (inside and outside). Use your finger to spread it evenly. 2. Spray silicon lube on a cloth and wipe the zipper (again, with the cooler open so you can do both sides.
Is the zipper supposed to be tough or soft?
The zipper has to be tough so it can retain water and fight the weather I have the big RTIC soft side. Yes, the zipper is stiff when they are new. It has to be tight or it can’t hold in water should the cooler tip. They do break in and get easier to open.
How do you clean the inside of a soft cooler?
Spray silicon lube on a cloth and wipe the zipper (again, with the cooler open so you can do both sides. Wipe it several times with the cloth almost wet with silicon lube. Allow to dry. Don’t understand the uber expensive soft cooler craze myself…..
Can you fix RTIC zipper?
RTIC will either repair or replace any broken or defective product, at our sole option. TO THE EXTENT PERMITTED BY LAW, THIS SHALL BE THE SOLE AND EXCLUSIVE REMEDY OF THE PURCHASER.
How do you fix a broken zipper on a cooler?
0:026:19Yeti Cooler Zipper Repair - YouTubeYouTubeStart of suggested clipEnd of suggested clipBut what i did is i took a dremel tool with a cut-off blade on it abrasive cut-off blade.MoreBut what i did is i took a dremel tool with a cut-off blade on it abrasive cut-off blade.
What can you use on a RTIC cooler zipper?
The zipper lube is not vaseline. It's silicon mixed with wax. Use it, it works. With the cooler open, spread it evenly along the teeth and both sides of the seals (inside and outside).
How do you lubricate a RTIC soft cooler zipper?
0:191:47New RTIC soft pack 20 30 40 cooler & how to clean and where to lubricateYouTubeStart of suggested clipEnd of suggested clipI put a little bit of water in it and put a little bit of detergent. And that's all you need youMoreI put a little bit of water in it and put a little bit of detergent. And that's all you need you just go around. And smoothly you know if you have anything to scrub you can use the other side of the
How do you fix a zipper that separates?
1:052:32How to Fix Zippers that Separate or Come Undone - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce it's on there tighten that thumb screw. Down. Bring it back to the beginning of the zipper. AndMoreOnce it's on there tighten that thumb screw. Down. Bring it back to the beginning of the zipper. And then you're just going to zip it up like you would any normal zipper. It's that easy.
How do you reattach a zipper pull?
3:0313:54How to Put a Zipper Pull Back On - If You Pulled it Off After Front Fly ...YouTubeStart of suggested clipEnd of suggested clipSide just the equal. Amount then i can hold it from the bottom. And the zipper will zip. Up. Okay soMoreSide just the equal. Amount then i can hold it from the bottom. And the zipper will zip. Up. Okay so that's how you fix.
What is the best lubricant for zippers?
If you have a can of WD-40 Specialist Silicone Lubricant on hand, you're in luck, because this is one of the best ways to unstick a stubborn zipper. Simply aim the nozzle at the stuck area and spray a little product onto it, wait a second and try again.
What is a good zipper lubricant?
Petroleum jelly or colorless lip balm.
Will Yeti replace a broken zipper?
If a defect occurs as the result of the Product's intended use according to the care instructions during the Warranty Period, we will repair or replace, at our discretion, the defective product or part. If the product has been customized by YETI, the customized mark will also be replaced.
How do you fix a zipper on a Yeti cooler?
0:062:07Yeti Hopper 30 Zipper Repair Video - YouTubeYouTubeStart of suggested clipEnd of suggested clipPull two teeth. Out. So you can get that slider all the way past it so i pulled those two teeth outMorePull two teeth. Out. So you can get that slider all the way past it so i pulled those two teeth out right there then what you're gonna.
How do you clean a soft cooler?
Pour in some detergent and then use your hose to add water to the cooler. There's no need to fill it all the way up. Use your sponge or scrub brush to work the soapy water into all the corners and grooves of the cooler's interior. You should also use your soapy sponge to wipe down the exterior of the cooler.
How do I install Fixnzip?
0:263:38FixnZip: Getting the Teeth to Engage - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo that the sides open up. And then just slide it right over the existing zipper teeth and get asMoreSo that the sides open up. And then just slide it right over the existing zipper teeth and get as close to that retaining box as possible. So when those are flush. Tighten down the thumb screw.
How do you put a zipper back on a Yeti cooler?
0:272:07Yeti Hopper 30 Zipper Repair Video - YouTubeYouTubeStart of suggested clipEnd of suggested clipPull two teeth. Out. So you can get that slider all the way past it so i pulled those two teeth outMorePull two teeth. Out. So you can get that slider all the way past it so i pulled those two teeth out right there then what you're gonna.
Will Yeti replace a broken zipper?
If a defect occurs as the result of the Product's intended use according to the care instructions during the Warranty Period, we will repair or replace, at our discretion, the defective product or part. If the product has been customized by YETI, the customized mark will also be replaced.
What is a good zipper lubricant?
Petroleum jelly or colorless lip balm.
How do you fix a broken zipper on a lunch box?
0:282:04How to Fix Broken Zipper or Separating Zipper - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd I am going to tighten it a little bit. And tighten it smashing down on this part right here.MoreAnd I am going to tighten it a little bit. And tighten it smashing down on this part right here. Let's see No okay I have to do it a little bit harder.
Why is a zipper tough?
The zipper has to be tough so it can retain water and fight the weather
How to clean a cooler seal?
Use your finger to spread it evenly. 2. Spray silicon lube on a cloth and wipe the zipper (again, with the cooler open so you can do both sides. Wipe it several times with the cloth almost wet with silicon lube.
Is the RTIC zipper tough to unzip?
After a couple of years the brothers RTIC zipper is still tough to unzip. Works well as a boat cooler though
Does yeti zipper come apart?
My buddy bought a Yeti Hopper for our Canada trip last year and the zipper basically came apart in pieces after one use. I’ve used a few others and didn’t like how hard it was to open the zippers.
Do soft sides have waterproof zippers?
Many of the soft sides have that have the waterproof zipper are this way from what I have seen.
Is the RTIC cooler good?
The RTIC soft side is awesome. Best cooler I’ve ever owned. It’s the only small cooler I’ve ever had that can sit in the sun in a boat for 2 days and still have ice left in it. Terrific ice-keeping ability for the size and weight.
What to put on a zipper to make it unzip?
Put zipper lube that came with it on it... makes it easy to zip and unzip.
Where are yeti coolers made?
The other four letter brand is not perfect either.#N#WHERE ARE YETI PRODUCTS MANUFACTURED? Our Tundra coolers are manufactured in the USA at facilities located in Iowa and Wisconsin as well as at a facility located in the Philippines. Our Hopper coolers and Rambler drinkware are manufactured in China.
Is RTIC a good product?
The squeaky wheel gets the grease... for every 100 good ones there is a bad one and they yell the loudest.. RTIC make a pretty good product for the price and usually runs good specials. It sucks some people got burned but we are talking about a cooler not a car or boat.
How many splits does a zipper pull have?
The actual zipper pull split in two .
What is FixNZip?
Theres a product called FixNZip. It's a zipper pull that clamps on and eliminates the need to remove zipper stops. Each size covers 3 zipper sizes. Quite useful to carry in the field in case of zipper failures as well
Do kayakers use coolers?
Us kayakers use AO coolers. I'm on year 2 with mine and have had numerous redfish and trout in them.
Is RTIC a replica Yeti?
People claim RTIC is an exact Yeti replica, yet they don’t honor a lifetime warranty.
