RV Awning Repair: Re-tensioning the Spring
- Step 1 – Prepare to Re-insert the Cotter Pin. When you release the tension in the spring, the cotter pin that is...
- Step 2 – Wind the Spring. Now that everything is in place for the cotter pin to be inserted, you will first need to wind...
- Step 3 – Re-insert Cotter Pin. When you are done winding the spring, have your helper...
How high of wind can RV awning withstand?
These kinds of awnings are usually rated as wind Class 2. Which means, they should be fine under19-25 mph of RV awning wind limits. If you would like to see some more resistance from such awnings, supporting them with a weather kit might extend it to 26-32 mph of wind resistance.
How to adjust an electric RV awning- a quick guide?
Step 1: Tools Required
- An RV with a manual awning
- Pole to pull the awning down
- At least 1 ladder (6' tall is good)
- A second ladder is helpful
- A screwdriver - possibly with a special head (I used a #2 square head)
- A helper
- 15 spare minutes
How to maintain your RV awning?
RV Power Awning Super Easy Maintenance How-to
- Cleaning the Awning the Easy Way. Our large 21 foot Dometic 9100 RV power awning is made out of vinyl and has held up very well after 4 years of ...
- Lubricating the RV Power Awning. The owner’s manual for the 9100 Dometic power awning states to use a silicone lubricant. ...
- Protecting My Vinyl RV Awning. ...
- RV Awning Roller Ball. ...
- Final Odds and Ends. ...
How to protect RV awning?
- The upfront costs are a bit pricey. If you purchase a cover, expect to spend over $100.
- Using a protector can add to your list of to-dos. The protector has to be put on and taken off your rig in order to protect the awning.
- You will have to manually install your RV awning protector. ...
How do you adjust the spring tension on an RV awning?
Standing at the front of the awning and facing the rear, you need to rotate the front awning leg counter-clockwise. Since this is the side with the ratchet catch, the awning might try to roll up on you some - just tell your helper to hold it tighter. Eventually, you should get it to rotate all the way around.
Which way do you wind an awning spring?
Most awnings have a spring on both ends of the tube. On the left spring (rear), turn clockwise about 8 turns. On the front spring, counter-clockwise 8 turns.
How do you rewind a spring on a Dometic awning?
0:0111:03RV awning retract spring replacement - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd hold it off it the spring was broken. Already it took the three rivets out you got to punch theMoreAnd hold it off it the spring was broken. Already it took the three rivets out you got to punch the middle out of the rivets that are on there. I.
How do you fix a sagging camper awning?
It's easy to fix a sagging awning — just crank the handle in reverse until the fabric tightens and be mindful of how the material is rolling. For the best results, make sure the cloth rotates over the top of the roller tube rather than spooling underneath it.
How do I reset my awning spring?
1:532:54Solera Awning - Replacing a Manual Awning Spring Assembly - YouTubeYouTubeStart of suggested clipEnd of suggested clipNext firmly grasp the end cap remove. The cotter pin. And put the recommended amount of tension backMoreNext firmly grasp the end cap remove. The cotter pin. And put the recommended amount of tension back onto the spring assembly by winding the end cap in the direction indicated. On top of the cap.
How do you adjust the tension on a slide out awning?
0:144:07How To Tighten an Awning Topper - Dometic - YouTubeYouTubeStart of suggested clipEnd of suggested clipBut what i did is i by hand relieved all the tension on the awning itself relieved it all and stuckMoreBut what i did is i by hand relieved all the tension on the awning itself relieved it all and stuck my my cotter pin quote-unquote cotter pin in there this is just a piece of wire hanger.
How do you tension a Dometic awning?
5:066:12How To: Adjust Your Awning Fabric - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo when they roll them up they never roll a lot properly that they can get them to come up and down.MoreSo when they roll them up they never roll a lot properly that they can get them to come up and down. So that's why we're shooting this video to make sure that you guys know how to adjust your fabrics.
How do you tighten the spring on a carefree awning?
Have your assistant hold and steady the support bar you're not working with. Rotate the support bar one turn to tighten the spring. Repeat the process on the other support bar, and reattach the support bars to the RV body with the screws. If the support bars are free-standing, simply rotate them to tension the spring.
Are electric awnings spring loaded?
Mechanical awnings use a torsion spring while electrical awnings use a motor in the roller tube.
Why will my awning not retract?
1:112:44How to fix an RV awning that will not retract properly - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo either that screw has come loose or possibly. They never installed it in the first place that'sMoreSo either that screw has come loose or possibly. They never installed it in the first place that's one reason to have an awning unwind or wind up unevenly. The other is that if the fabric.
How do you fix a bent RV awning tube?
fill the tube completely with fine sand under the bend- pack more rags to hold it in place. wedge the end under something sturdy and the lay a 2x4 under the center of the bend, apply pressure down at the same distance from the bend as is the other end that you wedged and see if it will straighten out.
How do I raise my awning?
2:034:431. How to Open a RV Awning - YouTubeYouTubeStart of suggested clipEnd of suggested clipThen on the side there's a lever on the side here you pull it straight out grab a hold of the arm.MoreThen on the side there's a lever on the side here you pull it straight out grab a hold of the arm. And raise the awning into the position. However high you would like it.
How do you wind an awning?
0:192:24Equipt 101: Awnings & Wind - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you face the awning into the wind the wind comes into the vehicle. And has to go somewhere. IfMoreIf you face the awning into the wind the wind comes into the vehicle. And has to go somewhere. If either has to go left right or up and typically it goes up.
How do you tighten the spring on a carefree awning?
Have your assistant hold and steady the support bar you're not working with. Rotate the support bar one turn to tighten the spring. Repeat the process on the other support bar, and reattach the support bars to the RV body with the screws. If the support bars are free-standing, simply rotate them to tension the spring.
How does an awning wind sensor work?
These wind sensors are designed to automatically retract an awning based on a predefined wind level. You can set it to retract to a moderate, 12mph breeze to a stronger breeze or near gale, of 31mph. It works by sensing wind-generated movement on the awning arms every 12 minutes.
How do you set up an awning for yourself?
4:386:01How To Setup and Pack Up Your 4x4 Awning - By Yourself. ) - YouTubeYouTubeStart of suggested clipEnd of suggested clipPush the light and then just push that up in there grab. Them a bit middle velcro strap do this oneMorePush the light and then just push that up in there grab. Them a bit middle velcro strap do this one first and that's going to hold your awning then in place.
How To Repair RV Awning?
Here are a few simple steps that you can follow to repair your camper’s awning successfully.
What to do if you stitch mending material to camper awning?
If you stitch your mending material to your camper’s awning, ensure that you find no visible or loose strings. Cut it if you see any.
What happens if you don't set an awning?
When you are attaching your awning, be sure that you fit it correctly to get optimal weather protection and shade. If the awning is not appropriately set, the chances of getting new tears and holes will increase significantly.
How to dry a awning?
Allow the awning to dry. Let it dry for a few minutes. If it is still wet, use an absorbent towel or a washcloth and gently dab the wet areas. Also, place any flat item underneath your awning to balance.
What to use to patch an awning?
If you haven’t patched it up soon enough, you will require different patching materials such as sewing supplies, a screwdriver, and a measuring tape. Instead of rushing and turning your awning into a horrible patchwork quilt, slow down and find the material that is of exact or somewhat close to your awning’s color.
What does it feel like to pull an RV out?
The sun has bright and radiant rays, and the birdies are chirping melodiously. After a while, you feel like stretching your legs, so you pull your awning out. That’s when you notice a tear.
Can you repair a tear in an awning?
Such tears are sometimes difficult to repair. Large holes: These holes are often caused when something moves across the awning. The sunlight and rain can pass through the holes easily. Once you know the damage, you can fix it quickly. The repair method of small tears and holes is straightforward.
How to rotate awning leg?
Standing at the front of the awning and facing the rear, you need to rotate the front awning leg counter-clockwise. Since this is the side with the ratchet catch, the awning might try to roll up on you some - just tell your helper to hold it tighter. Eventually, you should get it to rotate all the way around.
How to get awning to swing on ladder?
Set the awning pole on top of a ladder so the entire leg can swing around freely. As seen in the picture, I had to use a block on top of the ladder to get enough height. My helper is also holding the awning down so it doesn't fall off of the ladder.
How many sections are in an awning leg?
The awning leg consists of two sections. Let's raise that upper section up a bit. This should also pull the support arm out from the side of the camper as it is connected to the upper section of the leg.
Where is the release switch on an awning?
For most people, you need to first flip the release switch from "up" to "down." Mine is located at the top of the front of the awning roll. It's useful to have a long pole with a curved end to do this.
How many turns can you do on a spring?
If you are satisfied, move on. If not, then repeat the previous steps. Only rotate the legs one or two turns at a time, and don't do more than 4 or 5 total. If you over tighten the spring, it will break!
Step 2 – Wind The Spring
- Now that everything is in place for the cotter pin to be inserted, you will first need to wind the spring by the number of turns that is suited for your RV awningmodel or brand, and in the direction indicated in your tube's end cap. It's best to check your RV awning manual to determine the num…
Step 3 – re-insert Cotter Pin
- When you are done winding the spring, have your helper insert the cotter pin to hold that tension in the spring. Just like in process of releasing the tension, the cotter pin helps in holding or locking the spring to the desired tension.
Step 4 – Replace Arm and Bolt
- When you are done with locking the desired spring tension, it's time to replace the arm and bolts. The arm and bolts were disassembled when you released the spring tension. Now that you're done with re-tensioning the spring, it's time to replace the awning arm on the end piece and put back the bolt and secure it using a wrench.
Step 5 – re-install Awning
- The last step is to reinstall the RV awning. It's best to have three people for this job. Two people will handle the awning arms, one at each end, while another one will feed the cord into your awning rail. Just like that, your awning is back in action. You'll be sitting cool in the shade! When you purchase through links on our site, we may earn commissions at no cost to you.