This is how to repair a tilt steering column that has too much play in it. Step1)Disconnect Battery cable Step2) Remove the horn button and use a 13/16" socket to remove the nut. Step 3) Use a steering wheel remover tool to remove the wheel.
Full Answer
How do you unlock steering column?
Method 2: Unlocking Through Ignition Set Replacement
- Remove the column panels. Remove the column panels in the steering wheel. ...
- Free the lock cylinder. Free the lock cylinder by identifying the lock release tab in the ignition lock system, pressing it and turning the key till the cylinder mover ...
- Install the new ignition-lock system. ...
- Reinstall the columns. ...
How to adjust tilt steering?
To adjust the steering wheel:
- Pull the lever down.
- Move the steering wheel up or down.
- Pull or push the steering wheel closer or away from you.
- Pull the lever up to lock the steering wheel in place.
How do I lubricate a steering column?
How to lubricate the steering system
- Lubricating a rack and pinion. Support one end of the front-suspension cross member on an axle stand; place a container under the rack at the other end.
- Greasing track-rod ball joints. A ball joint with a grease nipple fitted underneath. ...
- Topping up a steering box. ...
How to tighten a loose steering column?
Tightening Your Tilt Steering Column
- Remove steering wheel horn button and assocated wiring.
- Remove steering wheel nut clip and nut then using a steering wheel puller, pull off the steering wheel. ...
- Remove the lock plate cover
- Remove lock plate with lock plate depressing tool (remove C-clip when lock plate is depressed

How do you fix a loose tilt steering column?
2:1913:21How to fix a loose GM tilt column - YouTubeYouTubeStart of suggested clipEnd of suggested clipOkay to start with I'm going to remove the pad or the horn button and basically there's two PhillipsMoreOkay to start with I'm going to remove the pad or the horn button and basically there's two Phillips screws in the backside you can get that off and you'll see a wire.
Can a steering column be repaired?
along with the make and model of your vehicle will be the deciding factors in how much the replacement of your steering column is going to cost. On average, you can expect to pay anywhere between $500 and $1,500 for the full replacement job at most auto repair shops.
How do you take apart a GM steering column?
4:1621:43Easy GM steering column teardown - YouTubeYouTubeStart of suggested clipEnd of suggested clipLet me take a screwdriver end and pop the little plastic clips loose. All right once you have yourMoreLet me take a screwdriver end and pop the little plastic clips loose. All right once you have your collar loose you can remove that and you're gonna see this metal plate.
How does a tilt steering column work?
A tilt steering wheel is one that adjusts for height. Upon releasing the adjustment lock on the side or the bottom of the steering column, the wheel will tilt up and down. It's not a huge adjustment — maybe 3 inches of travel — but it can make a big difference in a driver's comfort.
How much does it cost to repair steering column?
The replacement cost of a steering column is anywhere from $400 to $900. The cost for the steering column part itself will only be about $100 if it is used or $300 if it is new. However, the labor is what will cost you the most money for replacing the steering column.
What causes steering column problems?
Since dirt, dust and other debris can find its way into the steering column, it's possible for items to fall inside and block these gears from smooth operation. If you notice this warning sign, have a mechanic inspect the steering column, as it might be something small that can be easily fixed.
How do you put the steering column back together?
1:233:08How To Restore A Steering Column - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd don't forget the snap ring it's very important now just push the bearing with the rubber bushingMoreAnd don't forget the snap ring it's very important now just push the bearing with the rubber bushing into the housing making sure it's fully seated. Next slide the wires through the column.
How long does it take to replace a steering column?
Depending on your vehicle, the typical amount of time it takes to remove the old steering column and swap it out is anywhere between three to eight hours. Add it all up, and the total steering column replacement cost for you should fall around $450 to $950. As we said, it's not a cheap fix.
How do you wire a GM steering column?
2:145:18ididit Steering Column Wiring - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe brown wire goes to terminal kay. If you want to have four-way flashers you need to have theMoreThe brown wire goes to terminal kay. If you want to have four-way flashers you need to have the brown wire hooked up that is your four-way flasher feed into the switch.
How do you know if your steering column is bad?
If you notice that when you turn your steering wheel it feels loose or clunking, this could also be a sign. You may also notice that when you turn your steering wheel, you hear a squeaking or creaking noise. If your column tilt fails to lock in place, this is also a problem.
What are the types of the tilt steering column system?
Lower pivot Tilt Steering Column.Lower Pivot Steering Column.Lower pivot Tilt and Telescopic Steering Column.Upper Pivot Tilt & Telescope Steering Column.
When did tilt steering column come out?
5. Tilt-Away. Per Automotive Mileposts, as an answer to updated safety standards in 1967, Ford introduced the Tilt-Away Steering Wheel, which remained stationary but allowed the top section of the column to pivot up and over to the right.
How long do steering columns last?
You use the steering column every time you drive, but it's not subject to the same type of wear and tear as other components. In fact, your car's steering column should last for the life of the vehicle.
How much does it cost to replace a steering shaft?
Looking for Replacement Parts? We recommend Parts Geek for the best prices and selection. The cost to replace a bad intermediate steering shaft is would be anywhere between $200 and $350. The cost of the parts would be anywhere from $100 to $150, while the cost of the labor would be anywhere from $100 to $200.
How much does it cost to fix steering wheel controls?
For steering wheel control installation, parts typically cost $10–$300, but will vary. Your Geek Squad Autotech will provide an estimate prior to performing work that requires an additional charge (including nonstandard installation) and any additional parts.
When did GM start using tilt steering columns?
Prior to 1969, GM had tilt steering columns in production, but these were typically only available in their luxury models. From 1969 on up, tilt columns were readily available in most GM vehicles. These new tilt columns featured the ignition in the column rather than on the dash. Since then, hot rodders, street rodders and every one in between uses ...
How to remove tilt spring?
The tilt spring is held in place with a clip; use a flat tip screwdriver and compress the clip for removal.
What is the greasy mess on the steering wheel?
This greasy mess is the steering wheel lock and lock shaft, and-you guessed it-pull them out too.
Do GM tilt columns have problems?
These new tilt columns featured the ignition in the column rather than on the dash. Since then, hot rodders, street rodders and every one in between uses the GM tilt column when they build their cars. However great these columns are, they do have some inherent problems. After several years of use and abuse they tend to malfunction.