
Re: Replace water line from meter to house Author: packy (MA) i'd start at the 1" pex connection at the meter and run 1" pex all the way to the hard 3/4 copper. get two 20 foot lengths, a coupling, a 1 x 3/4 copper 90, a 1" pex x 1" copper street adapter and 4 crimp rings and rent or borrow the appropriate crimp tool.
Full Answer
How much does it cost to repair a water line?
Water Main Break Repair Cost. Repairing a broken section of your water main line averages $400 to $2,000. The price is at the lower end of the range if the breakage is small and easy to access. However, costs can be higher if the breakage is large and in an inaccessible area.
How to find the water line to a house?
Tips for Locating the Water Shut Off Valve Within the House
- In most cases, the shut off valve will be near the perimeter of the house.
- Keep your focus on-grade. ...
- Track a line from the water meter to the house. ...
- Sometimes the shut-off valve will be located behind a plastic access panel.
- A PEX plumbing manifold is a type of plumbing collection point that is increasingly being installed in newer homes. ...
How to replace a main water line?
West Avenue, between Carlton Boulevard and W. Michigan Avenue, is closing to traffic on Monday, April 18, for a water main and lead service line replacement project. City officials said in a release it’s because the city must replace antiquated water lines.
How to install a water line?
- Identify the water supply line you plan to tap and determine where to drill a hole to accommodate the refrigerator water line you will connect. ...
- Drill a 1/4-inch hole to run the tubing through.
- Follow the same steps as above to install either a self-tap saddle valve or a tee stop valve.

How do you replace a water line from the street to your house?
0:0211:12Water Main Replacement - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd that's 36 inches so we made it 36 inches deep the entire way after you have your trench dug downMoreAnd that's 36 inches so we made it 36 inches deep the entire way after you have your trench dug down to below the frost line the next thing you need to do is level out your ditch.
What type of pipe goes from meter to house?
Schedule 40 PVC or copper is the best way to go with water mains.
How do you connect a water line to a meter?
0:133:30Accessing your water meter to create water supply line - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo we have this fitting to fit on the meter here this is a push-to-connect fitting we're going toMoreSo we have this fitting to fit on the meter here this is a push-to-connect fitting we're going to use PEX tubing I'm gonna go to clean this out first.
How do you fix a high pressure water pipe?
If your pressure is higher or lower, then you'll need to install, repair, or adjust your pressure regulator to comply. Adjusting your regulator is easy, as long as it's working properly. Simply tighten the screw down clockwise to increase pressure and counter-clockwise to decrease pressure.
What size is main water line to house?
Generally speaking, the main pipeline from the street to your home is either ¾ or 1 inch in diameter. Supply pipes are ¾ inch in diameter and individual components are ½ inch in diameter.
What kind of pipe is used for main water line?
PVC PipesPVC Pipes Unless they are subject to some kind of damage, PVC pipes will last indefinitely. PVC pipe is also able to handle high water pressure. This is why it can also serve as your home's main water supply line.
How deep is a water line buried?
18 inchesUnderground piping shall be buried not less than 18 inches below the surface of the ground unless otherwise protected. All underground piping shall be protected from corrosion by coating in compliance with Section 533(b) or equivalent.
What size pipe comes out of water meter?
The bore of the meter is generally 5/8". a 5/8" x 3/4" meter has 3/4" AWWA Meter Threads and typically hooks up to a 3/4" water service line or larger. A standard meter coupling for a 5/8" x 3/4" water meter has male NPT pipe threads on one end and a swivel meter coupling nut with 3/4" AWWA Meter Threads on the other.
How deep is the water line to my house?
The lines run at least 3 feet below ground, which can make them difficult to find. Usually, if you know where the line enters the house and the location of your water meter or well, you know the line runs between these two points.
What happens if water pressure is too high in your house?
With high water pressure flowing and stopping in your pipes, it can cause long-term damage like small leaks. Might not sound too bad, but these leaks can lead to structural damage and even pipe bursts. It can damage your hot water heater.
Can I install a water pressure regulator myself?
Water pressure regulators can be a fun project to DIY if you have the know-how. The part usually costs around $50, while hiring a professional plumber to install one ranges from $250-350. Here's an overview of how it's done: Find the proper location.
Is 100 psi too high for water pressure?
If the pressure of the water entering your house is 100 psi or above, it can damage the plumbing. The pressure will cause dripping faucets and leaks in the pipes. It's also harmful to water-using appliances, such as water heaters, dishwashers, and laundry machines.
What is the water pipe outside of house?
These pipes are usually white in color and are made from PVC piping. Another pipe you may find on the outside of your home is a water pressure relief valve, also known as a PRV drain line. These pipes tend to be made out of copper and are designed to prevent water heaters from building up dangerous amounts of pressure.
What are the 4 types of plumbing?
Different Types of Plumbing Pipes used in Building ConstructionSoil Pipe.Wastewater Pipe.Rainwater Pipe.Vent Pipe.Anti-Siphonage Pipe.
What is a cracked water line?
A cracked or severed underground water line is a vexing problem that few homeowners ever want to face. Much like a broken sewer pipe, a broken underground water line appears that it might be an expensive, time-consuming project that upsets your entire life. But it doesn't have to be that way.
How to tell if you have a leak in your water line?
Determine If You Have a Leak. Some common indicators of a leak in your underground water line include: Unexplained increase in municipal water bills. Water meter indicator is spinning even though no water in or around the house is turned on. Mushy, soft spots in yard.
How far below ground level is water line?
Unlike sewer lines, which can run several feet below ground-level, water service lines typically are located just below your area's freeze line: from 1 foot to 3 feet below ground-level.
How to locate a leak in a house?
One way to do this is by running a sightline from your home's street-side water meter to the point where the water enters your home.
How long has Lee been remodeling?
Lee has over two decades of hands-on experience remodeling, fixing, and improving homes, and has been providing home improvement advice for over 12 years.
Can you use a shut off tool on a water valve?
It is preferable to use a dedicated water/gas shut-off tool. If you do not have one, you can fit an adjustable wrench over the valve and turn the wrench with a screwdriver inserted into the back off the wrench.
Can you repair an underground water line?
But it doesn't have to be that way. By separating this project into manageable steps, you can repair your underground water line by yourself, or at least take on some parts of it, thus reducing the project's overall cost. Repairing an underground water line is often less arduous than repairing a sewer line since the line is located closer to ground level. Plus, the digging can be done by hand, eliminating the need for hiring an expensive compact excavator.
