Repairing Guides

how to repair a delta shower diverter

by Prof. Paolo O'Reilly DDS Published 2 years ago Updated 2 years ago
image

How to Repair an In-Wall Delta Shower Diverter.

  • 1. Unscrew and remove the diverter handle. If the handle is plastic, there should be a Phillips screw under a decorative cap that you can pry off with ...
  • 2. Loosen the bonnet nut holding the cartridge in place by turning it counterclockwise with adjustable pliers. Unscrew and remove the nut.
  • 3. Grasp the stem of the diverter cartridge with the pliers and pull the cartridge out of the diverter housing. If the diverter is stuck, reattach the ...
  • 4. Inspect the cartridge for mineral deposits and chip them off with a screwdriver. You can also dissolve the deposits by soaking the cartridge ...

Full Answer

How do I repair the diverter in a shower?

How do I fix shower diverter?

  • Soak your faucet in vinegar to get rid of dirt and hard water residue.
  • Spray the diverter knob with cooking spray to lubricate its sticky bits.
  • Replace the shower diverter gate using a store-bought repair kit.
  • Replace the whole spout with a newer model from the hardware store.

How to replace a Delta shower diverter valve?

How do you change a Delta shower diverter valve?

  • Pop the handle's plastic button off with a blunt knife or ruler.
  • Loosen the screw on the handle.
  • Unscrew and remove the handle.
  • Remove the sleeve over the diverter.
  • Remove the diverter using a socket wrench.

How to fix the diverter in your shower?

What Is a Shower Diverter?

  • Step One: Prepping Your Area. First things first, you’re going to want to clear the area and make sure you are adequately prepared to fix your diverter.
  • Step Two: Accessing the issue. ...
  • Step Three: Removing Your Shower Faucet/Handle. ...
  • Step Four: Lubricate Your Shower Diverter. ...
  • Step Five: Correct Any Leaks. ...

How do you change a Delta shower diverter valve?

How do you fix a shower diverter valve?

  • Turn off the water supply to your shower.
  • Seal off your drain with tape so that small screws or other important parts are not lost down the drainpipe.
  • Tighten the screws behind the faceplate of the diverter valve. …
  • Disassemble the shower diverter. …
  • Replace the diverter.

What is a diverter cartridge?

Do you shut off the water before removing the shower diverter?

Do you need a diverter for a shower?

image

How do you fix a Delta diverter?

0:1110:13How To: Repair a Leaking Delta Tub Spout Pull-Up Diverter (for cheap)YouTubeStart of suggested clipEnd of suggested clipSome type of needle nose pliers a scraper. And abrasive sponge disposable gloves and 100% siliconeMoreSome type of needle nose pliers a scraper. And abrasive sponge disposable gloves and 100% silicone caulking. The main culprit of this type of leak is the tub spout gasket.

Can a shower diverter be repaired?

Once you've determined that your shower diverter is broken, don't delay in repairing it. Though it might be an easy task to put off, a broken shower diverter wastes water and creates a poor shower experience. Repairing a shower diverter is a home improvement project that you can complete in just one day.

How do you fix a push button diverter?

0:113:12how to fix a push pin tub diverter - YouTubeYouTubeStart of suggested clipEnd of suggested clipGet it loosened all those stem wrenches are pretty handy. So just loosen that up and pull it out ofMoreGet it loosened all those stem wrenches are pretty handy. So just loosen that up and pull it out of there. And then inspect the inside of that hole.

How do you fix a shower diverter pull up?

0:096:11Tub faucet spout diverter pull lever broke off - DIY fix - YouTubeYouTubeStart of suggested clipEnd of suggested clipAround the actual medium point of your spout. And the shower wall just carefully grab a utilityMoreAround the actual medium point of your spout. And the shower wall just carefully grab a utility knife and remove. It. And again in our case we just got this rubber seal you can purchase.

How do I know if my shower diverter valve is bad?

First, if the valve is engaged but water continues to come out of the tub spout only, the gate is severely damaged or has fallen out completely. Second, if the valve is engaged but the showerhead experiences low water pressure and water continues to drip from the spout, the gasket has failed or is starting to fail.

How much does it cost to replace a shower diverter?

Replacing a shower diverter valve costs $225 to $575, including materials and labor. A shower diverter valve switches the flow of water between the bathtub spout or shower head and is typically controlled by a small handle located on the center trim plate or near the tub spout.

How does a Delta shower diverter work?

0:000:49How Does a Shower Diverter Work? | The Home Depot - YouTubeYouTubeStart of suggested clipEnd of suggested clipComes in from the left cold. Water from the right the two are mixed in the valve. And will either goMoreComes in from the left cold. Water from the right the two are mixed in the valve. And will either go up to the showerhead or down to a tub spout a diverter directs which way the water goes.

How does a push button shower diverter work?

A diverter is essentially a tap which directs water to flow through a shower or bath spout. It's often a push-pull button that when pressed in or pulled out, will divert water to the correct fixture.

How do you replace a diverter spout?

0:153:36how to replace tub spout, change tub diverter. Easy! - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt. So first we're going to just try to spin this guy off. And it's spinning pretty easy we've got aMoreIt. So first we're going to just try to spin this guy off. And it's spinning pretty easy we've got a set screw under here. But it looks like this will probably just spin.

How do you fix a bathtub spout diverter?

1:077:29Tub Spout Diverter Repair or Replace? - YouTubeYouTubeStart of suggested clipEnd of suggested clipBut you might be able to just take a pair of pliers. And another pair of pliers. And hold the postMoreBut you might be able to just take a pair of pliers. And another pair of pliers. And hold the post while you unscrew. This probably the second easiest way is just to take a hacksaw blade.

How do you fix a bathtub diverter?

0:143:21Repair Leaking Tub Spout Diverter Pull in Shower Mode - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd pulling up on the diverter. Knob once that comes off all of the parts will come loose. So we'llMoreAnd pulling up on the diverter. Knob once that comes off all of the parts will come loose. So we'll take a look inside the tub spout in a little bit but first let's check out the washer.

How do you install a tub diverter repair kit?

1:143:44Replace tub spout diverter pull kit - DIY fix - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt comes down and you'll notice two little notches here or tabs. And this piece right here is goingMoreIt comes down and you'll notice two little notches here or tabs. And this piece right here is going to slide in place inside here with the rubber gasket on the opposite side of your pole.

How to make sure water is coming out of shower head?

1. Start this process by ensuring that the water is coming out of the tub faucet and not the shower head. Although it is not necessary to turn off your water supply, you want to make sure that if water does start coming, you don’t get soaked in the process! 2.

What tool to remove a screw from a faucet?

2. Note that the tool to remove the screw could be an Allen Wrench, Flat Head Screwdriver, or a Phillips Head Screwdriver. 3.

How to remove a knob from a sandbox?

Start by removing the knob. Find the screw, if not visible it is located under the plastic button which will need to be popped off using a small flathead screwdriver. 1. Once the knob has been removed, use your hand or a handle remover to remove the base.

Is it bad to have a shower faucet leaking?

It is never a good thing when your shower tub faucet starts leaking, but it is a good thing when you know what to do to fix it! As long as you have the time, tools, and parts for the job you can definitely learn how to fix shower diverter all on your own!

How to drain water from shower?

Go outside and turn on any of your home’s wall hydrants or faucets. Let it run for a few minutes. This will drain your home’s water supply. Head back inside and turn on the shower faucet. This will also help drain the last of the leftover water. You’ll now want to remove the handle.

Why does my water pressure change?

A change in water pressure, sudden changes from hot to cold, and consistent leaking can all be a result of a faulty valve cartridge. If you know this is the problem, then instead of replacing the whole unit, you can simply just change the valve cartridge. So, how do you do this?

How to tell if a shower diverter is a two valve or three valve?

When you remove a tee-valve from the wall, you find a single copper pipe. With two-valves and three-valves, you’ll find the corresponding number of copper pipes . If your shower diverter is a two-valve, focus on the temperature dial. This is because it often doubles as a shower diverter gate.

What to do if your diverter gate is stubborn?

If your diverter gate stays stubborn after your vinegar soak, try using a lubricant to make it work better. Any cooking spray will do, and you probably have some in the kitchen.

How to stop a handheld shower from leaking?

When you want to stop your handheld showerhead from leaking, you need to clean the inner parts of your diverter gate. Step 1: Turn off your water supply from the main spigot. This prevents flooding.

What does a shower valve do when it is not working?

If your bathtub has a showerhead, your shower valve redirects water from the showerhead to the tub faucet. When it’s not working, water simultane ously pours from both outlets. It’s easy to fix, so let’s learn how. Shower valves have two parts:

Why does my diverter gate keep squeaking?

Option 1 – Clean your spout. Sometimes, the diverter gate gets stuck. When you try to turn it or pull it up, it refuses to budge or makes squeaky, grating noises. If you do manage to pull it up, it may stick at the top and refuse to push back down. This is probably due to accumulated dirt, grease, and limescale.

How to clean a spout with vinegar?

If you like, you can mix the vinegar with water. Step 3: Wrap the plastic bag around your spout, submerging the spout. Step 4: Hold the bag in place using a rubber band, string, or shoe-lace. Step 5: Leave the faucet submerged for three or four days, checking it once a day.

What is a diverter cartridge?

The diverter includes a cartridge that can stick, leak or get blocked with mineral deposits. You have to extract the cartridge to repair it, and you can do that without turning off the water.

Do you shut off the water before removing the shower diverter?

While it isn't necessary to shut off the water to the shower before removing the diverter, it's important to keep the shower faucet off. If you turn on the hot water while the diverter is disassembled, you could be scalded. Chris Deziel has a bachelor's degree in physics and a master's degree in humanities.

Do you need a diverter for a shower?

By Chris Deziel. If your tub has a shower, you need a diverter to change the water direction between the tub spout and the shower head. Sometimes you find the diverter on top of the tub spout in the form of a knob that you lift to direct water to the shower. Delta manufactures tub/shower faucets with an in-wall diverter.

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9