Repairing Guides

how to repair a frost free outdoor faucet

by Miss Lesly Doyle Published 3 years ago Updated 2 years ago
image

  • Shut Off the Water. Shut off the water supply to the faucet. There may be a shutoff valve on the individual supply pipe leading to the faucet.
  • Unfasten the Faucet. Remove the mounting screws that are holding the faucet to the exterior wall. ...
  • Disconnect the Faucet. Disconnect the faucet from the supply pipe inside the house: Grasp the pipe fitting—where the faucet connects to the supply pipe—with tongue-and-groove pliers (aka " channel-locks ") ...
  • Remove the Faucet. Pull the faucet out from the wall on the exterior side. Purchase a new frost-free faucet of the same size.
  • Install the New Faucet. Apply plumber's pipe-seal tape to the threads of the new faucet, wrapping the tape two or three times in a clockwise direction (when viewed from the ...
  • Finish the Project. Turn the water back on—opening the shutoff valve slowly—and check the new connections for leaks (this is another instance when a helper is useful).

How do you repair an outside faucet?

on every outdoor faucet there is usually a large nut just below the turnkey. a good pair of channel locks are best for this. loosen up that nut and on the inside there's another threaded nut holding the inner housing to the outer... turn the key to loosen it and once you remove it you should see the end has a washer.

How do you repair a freeze proof faucet?

Worn-out Stem Washer or Cartridge

  • Shut off the water to the faucet, either at an indoor shutoff valve or by turning off water to the entire house.
  • Remove the handle from the spigot by removing the handle screw.
  • Unscrew the faucet mounting nut, and extract the entire stem from the faucet body.
  • Examing the washer and/or O-rings at the end of the faucet stem and replace them. ...

More items...

How to fix an outdoor faucet?

Outdoor faucets can develop leaks over time. Repairing or replacing the faulty parts will require a few standard tools.Shut off the water supply to the fauce...

How do you fix a leaking outdoor faucet?

How to Repair a Leaking Outdoor Faucet

  1. Prepare. Locate outdoor water supply valve, which is usually under the kitchen sink or in the basement. ...
  2. Remove the Faucet Turn Handle. Use the correct size and shape of screwdriver to take off the faucet turn handle. ...
  3. Remove the Spigot. ...
  4. Replace the Washer and Test. ...
  5. Access the Faucet Valve Stem. ...
  6. Replace the Washer on the Faucet Valve Stem. ...

More items...

image

How do you fix a freeze proof outdoor faucet?

2:5616:09How To Fix a Leaking Frost Proof Faucet | DIY Plumbing - YouTubeYouTubeStart of suggested clipEnd of suggested clipAfter you change it out put the cap. Back on. And if the leak was up here you've got it fixed. IfMoreAfter you change it out put the cap. Back on. And if the leak was up here you've got it fixed. If you put a vacuum breaker repair kit on it that was designed for yours.

How do you take apart a frost free faucet?

0:052:55Frost Free Faucet Repair - YouTubeYouTubeStart of suggested clipEnd of suggested clipWork around the outer diameter of the packing material. Until it dislodges. And comes out place theMoreWork around the outer diameter of the packing material. Until it dislodges. And comes out place the handle back on the rod without the screw. And turn the handle counterclockwise.

How do you repair a frost free Sillcock outdoor faucet?

0:213:15How to Fix a Leaky Frost Free Sillcock / Outdoor Faucet video - YouTubeYouTubeStart of suggested clipEnd of suggested clipOff I'm going to take off the center screw. Then remove the handle. And then underneath this nut isMoreOff I'm going to take off the center screw. Then remove the handle. And then underneath this nut is a washer and a lot of times the problems in this washer.

Can you fix frost free taps?

You may be able to fix the leak by simply cleaning the parts and reinstalling them. If this doesn't work, take the parts to the store to find replacement parts. Leaky, dripping exterior faucets not only waste water but also dump it next to the foundation, right where you don't want it. Luckily, they're easy to fix.

Why does my frost free faucet leak?

A leaking frost-proof faucet can waste a lot of water, but fixes are simple, whether the problem is the faucet stem washer assembly, the vacuum breaker, or just a loose retaining nut. Start with the retaining nut, then look for other problems. Tighten retaining nut.

How do you fix an outside faucet that won't turn on?

1:108:29WATER WON'T COME OUT!...EASY Fix for a Outdoor Water Faucet!YouTubeStart of suggested clipEnd of suggested clipYou just slap this right. On. Here turn clockwise until it shuts.MoreYou just slap this right. On. Here turn clockwise until it shuts.

How do you replace a valve stem on an outside faucet?

0:172:54How to Fix a Leaky Outdoor Faucet that has a Frost-Free Valve StemYouTubeStart of suggested clipEnd of suggested clipNow remove the handle by unscrewing the screw that holds it in place behind the handle you'll find aMoreNow remove the handle by unscrewing the screw that holds it in place behind the handle you'll find a packing nut turning counterclockwise use a wrench to undo the packing nut.

How do you fix a silcock?

1:032:20Repair Frostproof Sillcock - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce you've confirmed your water supply is off remove the stem from your frost proof silcock. InMoreOnce you've confirmed your water supply is off remove the stem from your frost proof silcock. In order to do this you'll need a wrench to loosen the packing nut behind the handle.

How do you repack an outdoor faucet?

1:375:13How to Fix a Leaky Hose Spigot | Ask This Old House - YouTubeYouTubeStart of suggested clipEnd of suggested clipTake the handle. Off take the bonnet packing bonnet nut off remove the bonnet packing if it's worn.MoreTake the handle. Off take the bonnet packing bonnet nut off remove the bonnet packing if it's worn. And then a new one goes on top of it now that's the simple way.

How do you fix a leak in a frost free hydrant?

0:432:14How To Adjust Leaking Water Source Frost Proof Yard Hydrant - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you still have a leak turn the water off repeat the loosening of the set screw and again raiseMoreIf you still have a leak turn the water off repeat the loosening of the set screw and again raise the handle five and a half inches or sixty degrees tighten the setscrew. And check for leaks.

How do you replace a frozen outdoor faucet?

1:236:19How to Replace a Frozen Outdoor Faucet with a Freeze-Proof OneYouTubeStart of suggested clipEnd of suggested clipUsing a twist drill bit drill out the 5/8 inch hole to a one-inch hole. Slide in the new freezeMoreUsing a twist drill bit drill out the 5/8 inch hole to a one-inch hole. Slide in the new freeze proof faucet and temporarily secure it in place with the screw.

How do you remove an outdoor faucet stem?

As I recall, you would follow this procedure...Turn off the water, so no pressure is found at the valve itself.Remove the handle, by unscrewing the small screw in the center. ... Remove the small nut around the stem.Put the handle back on. ... If the stem will not pull out, you need to pull out the packing around the stem.More items...•

How do you fix a leak in a frost free hydrant?

0:432:14How To Adjust Leaking Water Source Frost Proof Yard Hydrant - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you still have a leak turn the water off repeat the loosening of the set screw and again raiseMoreIf you still have a leak turn the water off repeat the loosening of the set screw and again raise the handle five and a half inches or sixty degrees tighten the setscrew. And check for leaks.

How do you fix a frost free hydrant?

0:0013:17How to repair an outdoor hydrant - YouTubeYouTubeStart of suggested clipEnd of suggested clipThe little rubber stop on the bottom aside. You know I'm going to pull it apart so this can kind ofMoreThe little rubber stop on the bottom aside. You know I'm going to pull it apart so this can kind of walk you through it on on on fixing.

How do I fix my nibco outdoor faucet?

0:004:25Leaky Hose Spigot Repair (NIBCO) - YouTubeYouTubeStart of suggested clipEnd of suggested clipToday i'm going to show you how to fix a leaking. Little nibsco nibco water spigot as you can seeMoreToday i'm going to show you how to fix a leaking. Little nibsco nibco water spigot as you can see there's a little pile of water. And noticed some leaks. Coming down here at the end of the spigot.

Where is the vacuum breaker on a frost proof faucet?

Most frost-proof faucets have a built-in vacuum breaker located on top of the faucet (Photo 4). If you see water dribbling out from under the cap when the water is running, it's leaking. Photos 4 and 5 show how to replace a leaking vacuum breaker. Some repair kits include the parts for this.

How do I fix a leaking faucet?

If you're lucky, you can fix your leaking faucet by simply tightening the nut under the handle. Don't crank it hard, though. If snugging it up doesn't solve the problem, turn off the water and remove the nut to repair the faucet.

How to fix a faucet that leaks from the handle?

In some cases, you can fix this by simply tightening the retaining nut that's under the handle. Remove the screw in the center of the handle and pull the handle off. Try tightening the nut slightly (Photo 1).

What to do if your faucet starts leaking?

If you find that the faucet starts leaking again after a short time, the valve seat is worn and you should replace the entire frostproof faucet. If the faucet is attached with threads, you can simply turn off the water, unscrew the faucet and replace it with one that's the same length.

What happens if a faucet spout is leaking?

If your faucet still leaks, the stem may be leaking and you should replace the faucet. If your faucet leaks out of the spout when it's turned off, the washer is bad. On frost-proof faucets, the washer is located on the end of the long faucet stem.

Can a frost proof faucet leak?

A leaking frost- proof faucet can waste a lot of water, but fixes are simple, whether the problem is the faucet stem washer assembly, the vacuum breaker, or just a loose retaining nut.

How long does it take to repair a frost free faucet?

When a frost-free faucet develops a leak, the homeowner can complete the necessary repairs in one hour or less, using a few basic tools and materials--all of which are readily available at a local hardware store or home center. Advertisement.

What is a frost free faucet?

The difference is that a longer frost-free faucet stem connected to the compression washer valve seals off the water supply inside the home rather than near the spout where the water would be exposed to the cold outside temperatures.

How to remove a packing nut from a faucet?

Remove the faucet packing nut by turning it counterclockwise with an adjustable wrench. Use lockjaw pliers to support the frost-proof faucet body while removing the packing nut. The packing nut is located directly behind the handle and has six flat sides to facilitate removal with a wrench.

How to Repair a Leaky Frost-Proof Faucet

Here are step-by-step instructions for how to repair a frost-proof faucet that’s leaking from a worn-out O-ring or washer.

Final Thoughts

Trust us, repairing a frost-free faucet looks much more complicated than it actually is.

Call 1-Tom-Plumber

Don’t hesitate to contact us here or call us at 1-Tom-Plumber (1-866-758-6237) if you need help repairing or installing a frost-proof outdoor faucet.

How does a frost free hydrant work?

How a Frost-Free Hydrant Works. A frost-free hydrant can be thought of as a very long compression faucet. The horizontal water pipe running out to the hydrant location from the house must be buried deep enough to be below the frost line, which in some climates can be 4 feet or more below ground. The actual valve body is located at ...

What makes a hydrant frost proof?

But what makes the hydrant frost-proof is a design variation that features a drain port built into the bottom of the valve. When the pump rod and plunger lift away from the valve seat, this drain port is blocked, forcing water to flow up the standpipe. However, when the pump rod and plunger are lowered down to close against the water inlet, ...

What to do if hydrant lever is not fully closed?

If the hydrant lever can't be fully closed, or if the faucet continues to dribble water when the lever is closed, you may need to adjust the hydrant's shutoff. Most hydrants have a square-head setscrew or a lock wheel that can loosened to allow for small adjustments to the position of the lever.

How to remove a pump rod?

Remove the Pump Rod. Carefully pull up and remove the long pump rod from inside the standpipe. If necessary, grip the rod with pliers to remove it; use pliers only on the outer portion of the rod, not on the brass spindle. Unscrew the old plunger from the end of the rod, using a screwdriver.

What is a frost free yard hydrant?

A frost-free yard hydrant is really just a variation on a standard compression faucet, in which a plunger at the end of a plunger stem opens and closes against a water inlet to control the flow of water. But in the case of a yard hydrant, the plunger is fitted onto the end of a long pump rod that runs down inside the vertical standpipe to ...

When a pump rod and plunger are lowered down to close against the water inlet, the drain port is

However, when the pump rod and plunger are lowered down to close against the water inlet, the drain port is opened and any water in the standpipe drains away into the ground—the surrounding area is usually packed with gravel to facilitate drainage.

Where do you turn off water lines in your house?

If there's no shutoff valve on the individual water line, you can turn off the water at your home's ​ main shutoff valve .

image
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9