Reassembling the Pop-Up Stopper System
- Step 1: Restore the Drain Stopper When you replace the drain stopper, screw it in the same way it was before. Just make...
- Step 2: Restore and Test the Pivot Rod Take the cleaned or new pivot rod with the ball attached, and insert it back...
- Step 3: Restore the Gasket and Retaining Nut Restore the gasket into place, and then screw...
Full Answer
How to remove stopper from sink?
Step by step guide on How to Remove a Bathroom Sink Stopper
- Try removing the stopper by hand. Some stoppers can be removed by hand without the need for any special tools or techniques. ...
- Remove items from under the sink. If you can’t pull the stopper out, you will need to go underneath the sink to release it – so the next ...
- Locate the horizontal plunger rod. ...
- Locate the clip attaching the rod and the strap. ...
How to fix a broken sink stopper?
Part 3 Part 3 of 4: Attaching the New Sink Stopper Drain
- Place a rolled out ring of plumber's putty around the sink opening. ...
- Push the new sink drain into the opening and onto the putty. Press firmly enough that plumber's putty squeezes out around the top lip of the drain.
- Stack any included gaskets on top of the locknut or bell housing. ...
- Tighten the locknut or bell housing nut to secure the drain in place. ...
How to put the drain stopper back in the sink?
Part 4 Part 4 of 4: Installing the New Sink Stopper Mechanism
- Align and place the drain stopper into the sink's drain opening. ...
- Insert the tapered plastic washer into the horizontal stub on the tailpipe. ...
- Feed the pivot rod into the stub and through the hole on the drain stopper. ...
- Feed the pivot nut over the pivot rod and tighten it onto the pipe stub. ...
- Install and connect the lift handle and extension bar. ...
How to install pop up Assembly in sink?
Reattach the Pop-Up Assembly
- Insert the pivot rod and ball into the opening of the tailpiece. The ball should fit snugly into the opening in the drain tailpiece.
- Slide the ball nut over the pivot rod and screw it onto the threads of the drain tailpiece.
- Slide the pivot rod through one end of the spring clip. Then, slide the pivot rod through the nearest hole in the clevis strap. ...
How do you fix a push down sink stopper?
1:319:28How to fix pop up drain waste plug - stuck or leaking - YouTubeYouTubeStart of suggested clipEnd of suggested clipMake sure you clean that up nicely. And then you want to inspect the seal. So make sure it's not dryMoreMake sure you clean that up nicely. And then you want to inspect the seal. So make sure it's not dry or crack if it is and simply replace it and they will fix your seal.
How do you fix a pop up stopper?
1:234:58How to repair or reassemble pop-up sink stopper DIY video ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipIn the opening in the back of the the pipe there. So now we are going to insert the new pit rod intoMoreIn the opening in the back of the the pipe there. So now we are going to insert the new pit rod into the back of the pipe. You'll want to test to make sure that it actually goes into one of the holes.
How do you reconnect a pop up sink stopper?
3:576:12FAST Sink Drain Stopper Repair - YouTubeYouTubeStart of suggested clipEnd of suggested clipPull push the stopper down a little bit farther.MorePull push the stopper down a little bit farther.
Can you replace a pop up sink plug?
Pop up sink plugs can be removed and replaced easily. For more complex installations, use an adjustable wrench or wrench.
How do you fix a lift rod on a sink?
3:244:41How to Install a Lift Rod in a Bathroom Sink - YouTubeYouTubeStart of suggested clipEnd of suggested clipWhere. You can see the control rod for the pop-up valve is moving up and down i've tightened theMoreWhere. You can see the control rod for the pop-up valve is moving up and down i've tightened the knot on the pop-up. Control bar up above. And d is moving it up and down.
How do pop up basin plugs work?
SO HOW DOES A SINK POP-UP MECHANISM WORK? It's actually a fairly simple design. When the lift rod is pulled upwards, it pulls the pivot rod up as well. This pivot rod is attached to the stopper, which is pulled down, effectively sealing the sink.
How do you fix a spring loaded pop up sink plug?
1:267:43How to fix a spring loaded pop up waste plug in a hand basin or bath tubYouTubeStart of suggested clipEnd of suggested clipSo what we typically do I would vies people to do is. You can just twist. This little plug piece itMoreSo what we typically do I would vies people to do is. You can just twist. This little plug piece it just spins. So loose right there. And it just comes off you just put that aside there.
How do you put a pop up drain back together?
1:393:31How to Install a Pop-Up Drain in a Bathroom Sink | Repair and ReplaceYouTubeStart of suggested clipEnd of suggested clipPush the drain collar down into the hole any excess putty will be pushed out and can be easilyMorePush the drain collar down into the hole any excess putty will be pushed out and can be easily removed after the rest of the drain is installed slide the rubber gasket onto the shaft.
How do you fix a spring loaded pop up sink plug?
1:267:43How to fix a spring loaded pop up waste plug in a hand basin or bath tubYouTubeStart of suggested clipEnd of suggested clipSo what we typically do I would vies people to do is. You can just twist. This little plug piece itMoreSo what we typically do I would vies people to do is. You can just twist. This little plug piece it just spins. So loose right there. And it just comes off you just put that aside there.
How A Pop-Up Stopper Works
Bathroom sink pop-ups are raised and lowered with a lift knob or lever, usually located on or near the faucet body. The knob or lever is connected...
How to Remove A Bathtub Stopper
It’s easy to remove a tub stopper to check it for mechanical problems or blockage. You’ll encounter a couple of different types of bathtub pop-ups:...
How to Fix A Sink Pop-Up Stopper
Water may leak or refuse to drain around a sink pop-up for a number of reasons. If your sink pop-up won’t pop up or seat properly, fixing it is qui...
How a Pop-Up Stopper Works
Pop-ups are simple mechanical devices that use a system of links and levers to move a drain stoppers up and down to seal a sink bowl or bathtub.
How to Remove a Bathtub Pop-Up Drain Stopper
It’s easy to remove a tub stopper to check it for mechanical problems or blockage. You’ll encounter a couple of different types of bathtub pop-ups: old-style mechanisms like the one shown in our illustration above, and newer spring-loaded pop-ups.
How to Fix a Sink Pop-Up Drain Stopper
Water may leak or refuse to drain around a sink pop-up for a number of reasons. If your sink pop-up won’t pop up or seat properly, fixing it is quite easy—usually just a matter of adjusting a few parts. The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism.
How to reattach clevis strap to pivot rod?
Reattach the clevis strap to the pivot rod through the same hole you marked when you slid it out. Changing the hole will give you different results than before for the top rod by the sink, making it a bit shorter or longer.
Can you unscrew a drain stopper?
You can now simply unscrew the drain stopper from the basin. If it needs cleaning, give it a good wash in another sink. However, if you are installing a new one, make sure you get the same size drain stopper.
