
How to Repair Broken Ribbon Wire
- Step 1. Sand one side of each half of the broken wire using very fine grit sandpaper. Remove just enough of the ribbon...
- Step 2. Lay both pieces of ribbon wire with the sanded side facing upward. The damaged ends should be touching each...
- Step 3. Place a small piece of flexible tape to secure the ribbon wire together from the bottom,...
Full Answer
Can You solder ribbon cable?
Soldering a ribbon cable can be somewhat tricky due to its thin individual wires. Turn the soldering iron on and set it at a temperature of 375 degrees Celsius (700 Fahrenheit). Place the connector where the ribbon cable is to be soldered on a flat and dry surface with soldering pins exposed and easily accessible.
How to fix a loose USB cable?
You can follow the method below to fix this issue:
- Take a toothpick and add a small drop of superglue, epoxy glue, or hot glue to it.
- Carefully place the drop on either side of your micro USB port
- Spread it in the USB port and let it dry for 10 to 15 minutes.
- Insert your USB cable to check if it works.
How to fix loose USB cable at your home?
Instructions:
- Carefully use the sewing needle to scrape around the inner perimeter of the USB-C port.
- From the corner, scoop out any of the lint.
- Shine the flashlight into the USB-C port to check for more lint. Repeat steps as necessary.
How to fix a frayed charging cable?
How to fix a frayed charging cable
- Flex Tape. ...
- Liquid Tape. ...
- Sugru. ...
- Electrical Tape. ...
- Talk to Apple (or just pick up a new cable) If you're still under warranty on your MacBook or have AppleCare, you may be able to get a replacement cable ...

How to connect ribbon wires?
Dip a flathead jeweler's screwdriver into the prepared epoxy and apply it to the ribbon wire. The epoxy should run in thin lines to connect the severed ribbon wires.
What is ribbon wire?
A ribbon wire or ribbon cable is a flat, wide strip of cable that contains multiple wires inside its insulation. If the wire becomes damaged by way of severing, the ribbon will not be able to achieve a proper connection. In order for the ribbon to perform, each of the multiple wires inside must be fully connected along the entire length ...
How to keep ribbon from moving?
Tape the ribbon down to the table to prevent it from moving. Ensure you leave the damaged ends of the wire uncovered.
How to sand a broken wire?
Sand one side of each half of the broken wire using very fine grit sandpaper. Remove just enough of the ribbon to expose the actual wires inside.
Can you run epoxy wires together?
Do not let the epoxy wire connections run together or the ribbon wire will not be repaired correctly.
Why did I trim the ribbon to where the first break in the conductors were?
The ribbon had a little bit of slack so, I trimmed it to where the first break in the conductors were so that I could insert the remainder into the slot. Unfortunately there was not enough metal left exposed to make the connection (<1mm on some of the pins).
How far back can I peel mylar?
Right at the edge of where the contact area starts I noticed a thin mylar top coating that I was able to peel back about 1/8 inch to the same width of the original, exposing brand new shiny silver contact area.
