how to repair drywall above shower

^{How to Repair the Drywall in the Bathroom Above the Shower/Bathtub}

1. Remove Crumbling Drywall. Remove the softened, crumbling drywall and scrape away any peeling paint. ...
2. Attach Furring Strips. Attach at least one furring strip (1 x 3-inch piece of wood) to the back of the existing drywall with 1 5/8-inch drywall screws unless ...
3. Cut and Install Greenboard. Measure the hole and cut a piece of greenboard drywall to fit. ...
4. Apply Joint Compound. Apply a coat of joint compound to the edges of the patch using a 6-inch drywall knife. ...
5. Apply Additional Joint Compound. Apply two more coats of joint compound, allowing it to dry completely in between coats. ...
Prime the Patch. Prime the patch with drywall primer and sealer or a coat of latex (water-based) primer.
Apply Silicone Caulk. Apply paintable silicone caulk along the top lip of the shower or bathtub stall. ...
Dispose of Excess Drywall. Don't rinse large quantities of excess drywall down the drain because it can settle and clog the plumbing.

How do you waterproof drywall above a shower?

What Kind of Drywall Do You Use for Shower Walls?

• It is far better to use waterproof backer board for shower walls instead of drywall.
• If you install drywall in your shower, it must be water-resistant drywall.
• Even if you use water-resistant drywall, it’s essential to install a waterproof membrane on top of it to add true waterproofing.

How to finish drywall where it meets the shower?

Remodeling Your Shower: How to Transition from Tile to Drywall

• The Beauty Of Tiled Showers. First of all, why would anyone remodel their shower and put in tiles? ...
• Common Challenges Going From Tile To Drywall. ...
• Ways To Transition From Tile To Wall. ...
• Creative Solution For Smooth Tile-To-Wall Transition In Showers. ...
• Cost Of Installation. ...
• Do It Yourself. ...
• Cost-Saving Tactics. ...
• Related Questions. ...

How do you finish drywall around a shower surround?

Tools You Will Need to Complete the Job

• Knives
• Tapes
• Level
• Chalk line
• T-square
• Hammer
• Drill
• Pry bar
• Screwdriver set
• Safety eyewear

How to install drywall in your shower?

Things You Will Need

1. Choose the right drywall for your shower The first step when building or restructuring a shower is choosing the right materials. ...
2. Seal the joints and cracks After you’ve installed the drywall panels, sealing the joints and eventual cracks is a crucial step before waterproofing its surface. ...
3. Waterproof the drywall

How do you fix drywall around a shower surround?

2:345:31How to repair Drywall around Bathtub - Step By Step - Part 7 - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd for the joints i'm using self adhesive tape it is very easy to work with it you just stick it toMoreAnd for the joints i'm using self adhesive tape it is very easy to work with it you just stick it to the wall. And cut it where you need.

How do you fix water damaged drywall next to tub?

3:347:17How to Waterproof Bathtub Drywall -- by Home Repair Tutor - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you have a tub surround like this one near the kerdi-band is pretty well adhere to the latexMoreIf you have a tub surround like this one near the kerdi-band is pretty well adhere to the latex paint in the part of the drywall that was damaged. Yeah it's in good shape.

What do I put on the wall above the shower?

You can apply moisture-resistant paint with a brush or a roller in the space above the shower panels. Although it costs more money, Bob Vila recommends using paint that has an anti-microbial/anti-fungal additive to prevent mold in humid areas.

How do you fill a gap between drywall and shower?

1:293:53Drywall gaps around tub and shower surrounds, How to fix them - YouTubeYouTubeStart of suggested clipEnd of suggested clipEverything needs something to bond to mix up some 20-minute speed set joint compound. And press itMoreEverything needs something to bond to mix up some 20-minute speed set joint compound. And press it into the gap keeping it flush with the drywall.

Is there waterproof spackle?

DAP 18741 Platinum Patch Filler This spackling dries to a waterproof solid and is compatible with various building materials, making it an excellent option for outdoor repairs. Whereas other exterior spackles require a coating of paint for protection, DAP Platinum is fully waterproof 24 hours after application.

Can you waterproof drywall for shower?

It is possible to waterproof drywall in a shower by covering the drywall with a waterproof membrane. This waterproof membrane can be bonded to drywall with thinset adhesive to create a waterproof layer. Never tile directly over drywall in a shower.

How do you finish a wall over a shower surround?

1:4511:26Finishing Drywall Around A Fiberglass Shower Surround - YouTubeYouTubeStart of suggested clipEnd of suggested clipOur piece up here too. So again remember your half inch side here your wider side goes into the wallMoreOur piece up here too. So again remember your half inch side here your wider side goes into the wall. And we're going to spray both the wall. And the edge of the trim.

What kind of drywall goes over shower?

It's best to avoid drywall completely when installing shower walls. Waterproof backer board—such as cement boards or polystyrene foam boards—are the best choice. They are easy to install and do not require extra waterproofing, since they're waterproof by design.

How do you waterproof a ceiling above a shower?

2:386:23Schluter®-KERDI over Solid Backing for Ceilings - YouTubeYouTubeStart of suggested clipEnd of suggested clipDepending on the size of the ceiling it may be necessary to install multiple sheets of Kirti toMoreDepending on the size of the ceiling it may be necessary to install multiple sheets of Kirti to cover the entire surface. Waterproof integrity is maintained at joints. Using two inch wide overlaps.

How big a gap can you fill with caulk?

A single bead of caulk can fill gaps up to 1/4 inch. If the gap is slightly larger than this, fill it with a bead of caulk deeper into the gap, but not flush with the surface. Wait until the caulk is completely cured before coming back to put a surface bead on.

Does drywall go over shower flange?

0:005:44How to install drywall over a tub or shower flange - YouTubeYouTubeStart of suggested clipEnd of suggested clipLike you and you and hope that's the case of mine. Over here where I've already started the existingMoreLike you and you and hope that's the case of mine. Over here where I've already started the existing sheetrock was probably a half-inch the face of this sheetrock a half-inch in front of the flange.

How do you caulk a large gap in a shower?

0:432:18How to Caulk Large Gaps in Bathtubs : Caulking Tips - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd cut a very small angle about an eighth of an inch off the top. You're going to cut it at about aMoreAnd cut a very small angle about an eighth of an inch off the top. You're going to cut it at about a 45 degree angle. Now taking your caulking gun go ahead and load up your caulk.

Does water damaged drywall need to be replaced?

If the sheetrock is still firm after drying out the wet drywall you may have lucked out of replacing the whole section. However, if the water has seeped in and has started destroying the fibers that make up the drywall you will need to replace it before a collapse takes place or mold appears.

Can water damaged drywall be repaired?

If drywall panels only show water stains but aren't structurally compromised, they may be repairable by cutting out the damaged portion. When cutting out around the damaged area, use a keyhole saw to cut the hole into a square or rectangular shape. You can then make a patch with another piece of drywall for the repair.

Does wet drywall always need to be replaced?

Wet drywall does not always need to be replaced. In some cases, you can dry out and save your walls if you act quickly. However, whether you can save them depends on a few factors. How Much Water is Involved The more water involved, the less likely you'll be able to save wet drywall.

How do you fix water damaged bathroom walls?

Follow these steps to do so:Step 1: Remove the tiles from the affected area. ... Step 2: Remove the base or shoe trim. ... Step 3: Locate the next closet stud. ... Step 4: Cut out the damaged drywall. ... Step 5: Replace rotted studs. ... Step 6: Replace the removed drywall. ... Step 7: Fill in screw holes and seams.More items...

How to apply texture to a wall?

Apply the primer to the wall where you applied the new texture. Use a paintbrush to prime small areas or a small roller to prime medium size areas. Allow the primer to dry completely. Apply a second coat of primer and allow it to dry.

Why does my bathroom wall peel?

By Mona Culberson. Hot, steamy showers can cause the drywall to start peeling from the bathroom walls if the room isn't adequately ventilated. When a tight budget doesn't allow the addition of more vents, leave the door open, or use a fan to keep the air circulating. You can do the repair yourself and save money.

How to smooth out rough edges?

Put on a dust mask. Sand the area lightly to smooth rough edges where material was removed, using a fine-grit sanding pad. Brush the sanding dust off with a whisk broom.

How to mix paint to match wall color?

Pour paint into a paint pan and apply it to the primed wall using a paintbrush or a small roller. Allow the paint to dry completely. Apply a second coat of paint and allow it to dry completely. av-override.

Repairing Wet Drywall Near The Shower- 2 Different Methods

There are two general ways of fixing wet drywall. We’ll go over them both in detail. The first method is very simple and doesn’t require much work. But the other method will need a little hard work.

Method 1: Drying Up The Drywall

This option is viable when the damage is minimum and hasn’t reached a wide area yet. It won’t do you any good if there’s too much moisture build-up.

Method 2: Replacing Wet Drywall

If you’ve chosen this option then that must mean your drywalls aren’t doing very well. Don’t worry, you can fix your drywall in no time. We have broken down the process into 3 steps for your better understanding.

Can you use shower bead to finish a gap?

The last possibility is to use a manufactured shower bead to finish the gap directly. Essentially, it is a pre-made product that allows you to split the difference between the first two methods. This plastic bead consists of support leg attached to a long mud leg, allowing you to attach them directly across the gap between the rock and ...

Can you use drywall to back up a shower?

It may seem obvious, but drywall should not be used to back the tile in the shower or bathtub enclosure, as sheetrock breaks down in the presence of moisture. Using drywall as a substrate for the tile is a recipe for potentially costly repairs (and probably after a relatively short time, too!).

Does Schulter Kerdi waterproof?

Certain waterproofing products (such as Schulter Kerdi) offer a warranty on their waterproofing capability even when drywall. is the substrate, but unless you have such a product, avoid putting drywall in direct proximity with the wet area of the tub or shower.

The Problem

While not as reliable a wall covering for a shower as fiber cement board, greenrock does last for many years if properly maintained. It needs a waterproof coating, however, and many people paint it with oil-based paint. Problems arise when water seeps under the paint because, while the core repels water, the paper facing doesn't.

Removing Damaged Drywall

You have to remove the crumbled drywall in order to replace it, and the repair will be neater and more effective if you remove more than just the damaged section. Cutting out a large section that extends to the studs on either side doesn't create an extra expense, and it makes it easier to measure and attach the replacement.

Installing Replacement Drywall

Greenrock comes in 1/2- and 5/8-inch sheets, so be sure to measure the thickness of the existing material. You may be able to find a partial sheet of the drywall you need at a lumberyard. Before installing it, you need an accurate measurement of the dimensions of the rectangle so you can cut a matching one with a utility knife or drywall saw.

Finishing the Drywall

Because of the extra moisture and stress on the drywall caused by the movement of the shower stall relative to the studs, it's a good idea to tape the joints around the replacement with fiberglass mesh tape and hot mud. These materials form stronger joints than paper tape and conventional mud.