Follow these Steps to repair a patio heater
- Before attempting any repairs, make sure the Patio heater is turned off and disconnected from the power source.
- Check that the fuse or circuit breaker is not blown and replace the fuse or reset the circuit breaker if it is blown.
- Remove the cover of the patio heater and check the pilot light. If it’s out, relight it...
How do you clean a Propane patio heater?
To clean the pilot tube, you need to take these steps:
- Turn off the outdoor patio heater and disconnect the fuel. ...
- Remove the top cover of the patio heater to the manufacturer’s instructions
- Find the burner assembly
- Use a cotton swab soaked in alcohol over the burner assembly holes
- Find the venturi tubes (silver tubes on the back of the assembly)
Why will my patio heater not light?
Why will my patio heater not light? Yet another reason your patio will not stay lit is that the gas valve orifice is blocked. You should clean the orifice or have it replaced. Sometimes there is air in the gas line which is blocking propane from getting to the heater head unit.
How to install a patio heater step by step?
Step 1: Center the Heater Hat over the hood of the heater. Step 2: Insert the self-tapping screw through the washer hole. Step 3: Place the screw and washer combo over the predetermined holes on the Heater Hat. Step 4: Using the power drill, drill the screws to a snug fit, on the hood of the heater. Self-Tapping Screws, & Stainless Steel Fender ...
How to light patio heater manually?
- Hold the control knob in and apply force to it so it stays pressed in.
- Carefully using a lighter ignite the flame. You will need to put the lighter into the match lighting hole on the patio heater.
- Once a flame appears gently release the pressure you have been applying on the control knob.
- Sit back and enjoy the warm glow.
Why is my patio heater not working?
Check for debris around the patio heater burner pilot and clean out insects and ensure the area is clean and dry. There may be low fuel pressure, ensure the gas cylinder has sufficient fuel and is turned ON at the regulator. Ensure the regulator is not worn and working OK.
How do you fix a propane heater that won't stay lit?
If the thermocouple is too far from the flame, this can cause the pilot to go out and shut down the propane heater; you can fix this easily by moving the thermocouple closer to the flame. The thermocouple could also be worn out, in which case it needs to be replaced.
How do you troubleshoot a propane heater?
2:056:53Propane Patio Heater Troubleshooting - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce again a shaded area this is the spark you want to make sure you got a spark first of all whichMoreOnce again a shaded area this is the spark you want to make sure you got a spark first of all which the spark ignites your pilot light.
How do I test my patio heater igniter?
The igniter (or sparker) can be the cause of the problem. There's a simple way to test for this: try lighting the heater manually with a stick lighter. If this works and the burner ignites, then the igniter is at fault. These do get worn out with time and use, and they're easy and cheap to replace.
How do you clean a thermocouple on a propane heater?
3:485:35How to clean Thermocouple in propane heater-How to ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipRegion and this is what you need to clean it with just some steel wool. And just come right alongMoreRegion and this is what you need to clean it with just some steel wool. And just come right along the thermocoupler. Be gentle any soot any carbon that's built up on there.
Can you manually light a patio heater?
1:333:10How To Light Patio Heater With Lighter or Match Easy SimpleYouTubeStart of suggested clipEnd of suggested clipWith the ignition button we're gonna twist the knob to pilot. Meanwhile we press it down and hold itMoreWith the ignition button we're gonna twist the knob to pilot. Meanwhile we press it down and hold it for forty-five seconds to one minute now.
How do I reset my propane heater?
Relight the pilot light by holding a lit match to the pilot flame jet's opening. Turn the circuit breaker back on, and then turn the main gas supply back on. Press and hold the reset button for about 30 seconds and raise the temperature on the thermostat.
How do you purge the air out of a gas patio heater?
Depress the patio heater control knob and turn it counterclockwise until it stops. Continue holding the control knob depressed for 1-2 minutes. This will bleed out any air bubbles in the gas line.
How do you replace a thermocouple on a patio heater?
1:446:37How to Replace the Thermocouple on Pro Series Item #'s 61159 & 61436YouTubeStart of suggested clipEnd of suggested clipAlright it's possible to take it apart just with needlenose pliers you all you to do is get this nutMoreAlright it's possible to take it apart just with needlenose pliers you all you to do is get this nut right here loose. And then you can unscrew it with your finger. This is the thermocouple.
Why is my gas heater not igniting?
If your gas furnace initiates the start cycle but does not fire up, it's likely because of a faulty, damaged, or dirty ignitor/sensor. This is a very common furnace problem—you can try to clean the sensor and replace the ignitor.
What causes a gas heater not to light?
If your furnace won't ignite, the source of the issue may be a broken flame sensor. The sensor is responsible for turning off the gas burners to avoid gas buildup. Once this component starts to malfunction, it may stop the burners from igniting altogether.
How do you fix a gas heater igniter?
2:393:53Furnace Not Igniting? - Ignitor Testing & Replacement | Repair and ReplaceYouTubeStart of suggested clipEnd of suggested clipAnd you will have to replace the igniter. Align the new igniter. And tighten the screw. NowMoreAnd you will have to replace the igniter. Align the new igniter. And tighten the screw. Now reconnect the wires. Now replace the upper. Cover. Next open the gas valve.
Why does my pilot light go out when I release the pilot light knob?
If you're able to light the pilot light, but it goes out when you release the control knob, the thermocouple probably needs replacing. The thermocouple is a safety device that shuts off gas flow if it senses the pilot light is out, but when damaged it loses its regulatory ability.
Can I bypass a thermocouple?
Realistically, you have just disabled the thermocouple, but you can also reach in and unclip it from its holding bracket where it meets the pilot light. In most cases it will be held on with a gravity clip, but some are held on with a screw that must be removed with a small screwdriver.
How do you unclog an outdoor heater?
The best way to unclog your heater is to use a can of compressed air and blow out the burners.
How much of a thermocouple should be in the flame?
The pilot flame should cover about ½ inch of the thermocouple.
How do you clean a thermocouple on a patio heater?
Start by turning off the propane heater and disconnecting the fuel supply. Use a screwdriver to unscrew it and remove it from the pilot assembly. R...
How long does a thermocouple last?
A properly functioning thermocouple should last at least a few years but will probably need to be replaced after 5 years.
How much does it cost to fix a thermocouple?
It will cost between $150 and $250 to replace the thermocouple within your patio heater.
How to tell if a patio heater is damaged?
Signs of damaged wires include corrosion, frayed wire and broken wire insulation. Exposure to the elements, rodent infestation or simply age can lead to wire issues. A wall-mounted patio heater’s electrical wiring is especially prone to damage from birds if they build nests on top of them. Damaged wiring can’t be fixed.
What happens when you stack a patio heater?
When these elements stack up on a patio heater’s gas or electric heating element, the heater may have starting issues or reduced heat production. If your patio heater has these issues, cleaning it could be all you need to do.
How to unclog a gas line?
To unclog the line, start by removing the emitter screen with a screwdriver to expose the ignition assembly. Grab a small wrench and loosen the orifice from the gas line.
What is a thermocouple on a patio heater?
The thermocouple of a gas patio heater is a safety component designed to prevent gas leaks when the pilot goes out. It’s a copper rod that sits next to the pilot tube on the other side of the spark igniter; it allows gas to flow through the pilot tube when it detects heat from the pilot light.
Why won't my electric heater start?
Electric heater doesn’t start, or starts but doesn’t work right. Damaged or corroded wiring is one of the most common causes for electric patio heater problems. This includes everything from the heater not starting at all to a whole host of malfunctions while it’s running.
How to replace spark igniter?
To replace the spark igniter, note that it is usually secured to the ignition assembly by a single retainer nut that can be removed with a wrench. On the other end, it’s usually linked to the ignition switch wiring with a push-in connector that can be easily pulled out by hand.
How to clean a gas burner?
Reattach the screen. To clean a gas burner’s individual ports, remove the emitter screen and take a pipe cleaner or straw brush to remove dirt and debris. Once clean, reattach the screen.
Why is my gas heater not lit?
Sometimes the heater will stay lit but the flame is too low. This could mean that the gas pressure is too low. When the outdoor temperature is less than 40 degrees F and the tank is less than one-quarter full a low flame will result. Furthermore, the problem may also be in the regulator.
What to do if gas is on but no gas flow?
Furthermore, the problem may also be in the regulator. If the gas is on but there is no gas flow then replace the hose and regulator assembly. If your propane tank is new you will need to purge the air from the gas lines. As described before opening the gas line by turning the knob on the propane tank to fully open.
Can you start a patio heater with a lighter?
You can start your patio heater with a stick lighter. If the heat er will ignite with a stick lighter then replace the worn ignition with a new ignition. Sometimes the gas pressure is simply too low; often this issue happens with BBQ Grills. See our post How To Reset a BBQ Grill Regulator.
Do I need to disassemble a patio heater?
You may not need to disassemble it as much as you think, but you need to disassemble and very gently squeeze the pilot and thermocouple making sure not to crush it. Now, the pilot light will be very close to the sensor bulb and the patio heater will no longer shut off after a few minutes.
Why is my propane patio heater not heating?
If your propane patio heater is experiencing a lower amount of heat, this could be due to a leak somewhere in the gas line process. While this might not be much of a threat to your patio heater, gas leaks should always be handled with caution for your own health and safety.
How do patio heaters ignite?
One common way that gas patio heaters ignite is through an igniter. Much like with a BBQ starter, it creates a spark that ignites the gas released by the tank which causes a controlled flame to shoot up through the tube. This controlled flame is what creates the heat and warms up the space around the patio heater.
What happens if you wire an electric heater incorrectly?
If the wiring is done incorrectly, your heater might not work properly, or it could become a ball of flames. Let a professional handle wiring issues on your electric patio heater. The best way to resolve this issue is to take preventative care to ensure it doesn’t occur in the first place. 5. No Pilot Light.
Why is it important to have a gas line on a patio heater?
It’s important to get the right size gas line, otherwise you might find yourself with a new leak or pressure failure. The reduced heat is caused by less gas being supplied, so the new, undamaged line should be enough to get your patio heater back to producing at full capacity. 3. Infestation of Bugs and Critters.
What are the problems with electric heaters?
4. Faulty Electric Heater. While electric heaters are certainly easier to use and maintain, they do come with one problem that can be quite difficult to fix; faulty wiring. Gas and propane patio heaters have the advantage of most components being easy to access and fix, but electric heaters are much more intricate.
Can a patio heater be fixed?
Here are a few of the most common issues with a patio heater that can easily be addressed and fixed on your own. These issues can certainly cause some headache, but shouldn’t be the end of the line for your patio heater. As long as maintenance is taken care of and your patio heater is properly cared for, then you should be good to go for years on end.
Can a patio heater be used for small animals?
When the weather is cold, small animals will look for a warm place to stay. In this case, the warm location maybe your patio heater, especially right after use. If you notice signs of rodents or small animals nearby, it’s a good idea to check your patio heater.
What to do if your heater is not light?
If you have carried out all the checks and the heater will still not light, you can repeat all the checks more slowly and carefully or take your heater to a specialist for a service. Any other modifications that do not involve ignition issues on your individual heater will vary according to the manufacturer.
What to do if gas heater won't light up?
If there is a spark but the heater will not light up, try using a lighter or burning spill to light the gas. If you still can’t get it to light, verify the following parts are in working order so you can be sure the gas is making it to the burner.
How to tell if thermocouple is broken?
A good indication that the thermocouple has broken down is that the pilot light goes out when you try to turn the heater on.
What is the flip switch on a patio heater?
Some regulators have a flip switch that prevents the valve in the top of the cylinder from being depressed, effectively acting as an "off" switch. If you find such a switch on your patio heater, make sure that it’s set to the "on" position. Clear Gas Pipe.
Why does my gas heater not work?
As with other gas appliances, one obvious reason they fail to work is that there’s no gas. Look toward the base of the heater and take out the gas cylinder. If it’s light in weight, it may be empty, and you should replace it with a full one.
Can a gas patio heater be used outside?
Gas patio heaters can be useful additions to yards or outdoor areas, but they’re also quite simple devices from a technological standpoint. While there are a number of specific mechanisms that allow them to function, overall the only elements that a gas heater needs to work are flame and fuel. Due to their straightforward design, on ...
