In order to repair your rc car antenna, you will need to have a phone cord, a stick of some sort and a knife. Once you have these you will need to strip the wires and connect them with the broken antenna and use the stick to hold your new wiring up on the car.
Is your Traxxas receiver antenna properly lengthed?
Whether you've just wrapped up performing some maintenance and cleaning or you opened the box to your new Traxxas R/C vehicle it's a good idea to check the receiver antenna for proper length. The antenna wire runs from the receiver inside the receiver box to the antenna tube.
Why is my Traxxas receiver not binding to my car?
If your transmitter has a telescopic antenna, make sure it’s completely stretched. See if your Traxxas’s reception antenna fits correctly. Check to make sure if the antennas aren’t twisted or damaged. Or if they are not touching any of the metal parts in your car. A lot of times you’ll see the receiver isn’t binding because the ESC is compromised.
How do I return a damaged car to Traxxas?
Do not return the car or damaged components to Traxxas without first speaking with a service technician, toll-free, at 1-888-TRAXXAS. Many times, we are able to resolve an issue over the phone in minutes.
Where can I buy replacement parts for my Traxxas?
You can locate your nearest dealer by clicking here. If you do not have a local dealer, you can purchase parts at online retailers, or directly through Traxxas at www.traxxas.com. Now that you have the replacement parts needed to repair the vehicle, simply reinstall them in place of the damaged parts you removed earlier.
How do you fix a broken RC receiver antenna?
0:507:30How to repair a broken receiver antenna - YouTubeYouTubeStart of suggested clipEnd of suggested clipWe will need a roller. And if you're not making notes you'll need a calculator because I'm going toMoreWe will need a roller. And if you're not making notes you'll need a calculator because I'm going to first of all this. This cable that we're looking at here is not just a piece of wire.
How do I fix my Traxxas receiver?
0:565:31Antenna Replacement Traxxas Receiver Repair Soldering Used ...YouTubeStart of suggested clipEnd of suggested clipThe plastic sticker using a small screwdriver. You can see there's a large tab and two small tabs onMoreThe plastic sticker using a small screwdriver. You can see there's a large tab and two small tabs on the large tab spread it open. And pull the receiver apart.
How do I fix my 2.4 Ghz antenna?
0:494:26How To Repair 2.4Ghz Receiver Antennas - YouTubeYouTubeStart of suggested clipEnd of suggested clipLeft well once it gets damaged you just want to clip off the bad part which I've already done here.MoreLeft well once it gets damaged you just want to clip off the bad part which I've already done here. Next you need to find the length of single wire that you need exposed. And I'll say most receivers.
How do you fix the antenna on a Traxxas Rustler?
1:153:30RC "How To" Replace Antenna On Traxxas 27mhz RC RecieverYouTubeStart of suggested clipEnd of suggested clipSo I just go ahead and I choose this antenna wire that I got off my old stereo 22 gauge is the bestMoreSo I just go ahead and I choose this antenna wire that I got off my old stereo 22 gauge is the best way to go cut it to the length that you need and then you're going to get some wire strippers.
How do you solder a receiver antenna?
1:172:59HOW TO Direct Solder Antennas To RC Receivers Or A Video TransmitterYouTubeStart of suggested clipEnd of suggested clipThe ground pad not the ground pad but the actual ground wire. And be able to solder that onto. TheMoreThe ground pad not the ground pad but the actual ground wire. And be able to solder that onto. The board itself as well. But take your time be real patient.
Why does my Traxxas lose signal?
Moisture can damage the receiver. Ensure that it remains dry. If damaged, Return the component to Traxxas for service, or replace the receiver with a new one. Switch crystals to a different frequency.
How do you fix a radio antenna wire?
0:072:21Car am fm antenna repair - YouTubeYouTubeStart of suggested clipEnd of suggested clipPiece that you're cutting that you're using. And on your car doing the exact same steps i'm doingMorePiece that you're cutting that you're using. And on your car doing the exact same steps i'm doing right here just uh take the stranded wire twist it together that's your ground that's the antenna.
How do I extend the range of a 2.4 Ghz transmitter?
1:009:26Boost UHF Range with 2.4ghz Relay / Repeater for Long ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipLink you just name any uhf transmitter there will be a way to use a receiver a 2.4 gigahertzMoreLink you just name any uhf transmitter there will be a way to use a receiver a 2.4 gigahertz receiver and use it as a relay.
What is receiver antenna?
A receiving antenna performs the reverse of the process performed by the transmission antenna. It receives radiofrequency radiation and converts it into electric currents in an electric circuit connected to the antenna. Household TV receiving antenna.
How do you install a Traxxas antenna?
0:061:16TRAXXAS SETUP -- SETTING UP THE ANTENNA (HD) 4 OF 21YouTubeStart of suggested clipEnd of suggested clipOn revote the wire exits the rear of the receiver box shown here on other Nitro models the receiverMoreOn revote the wire exits the rear of the receiver box shown here on other Nitro models the receiver is in a protective balloon with the antenna wire coming out of the end of the balloon. Pull.
How long is a 2.4 Ghz antenna?
The length of the antenna on a typical 2.4GHz receiver is 28.8 to 32 mm long, most are about 28.8 mm. The antenna is that length of bare line often at the end of a longer coaxial cable to move the antenna farther out from the receiver.
How do I hide the antenna on my Traxxas Slash?
0:491:42Quick Tip - Response to "Hide Your Antenna" - YouTubeYouTubeStart of suggested clipEnd of suggested clipThrough the chassis. Let's come around the front servo here and back along the chassis and I've gotMoreThrough the chassis. Let's come around the front servo here and back along the chassis and I've got it pinned under here with the rest of the wires.
How do you reset a Traxxas receiver?
2:314:09How to BIND and Factory RESET Traxxas radio - YouTubeYouTubeStart of suggested clipEnd of suggested clipIt to the left press the button. Once gonna flash quickly twice you're gonna go to the other side.MoreIt to the left press the button. Once gonna flash quickly twice you're gonna go to the other side. Press it again this will go red you're gonna go throttle. Press it once boom.
Why is my Traxxas receiver blinking red?
If the Low-Voltage Detection (LVD) is "ON" when a nickel-metal hydride (NiMH) battery is used an ESC may show the over-voltage alarm, indicated by a flashing red and green light. When using a NiMH battery in your Traxxas vehicle, it is important that the LVD remains "OFF".
How do I reset my Traxxas controller?
0:172:36How to Reset the TQi Radio System | Traxxas Support - YouTubeYouTubeStart of suggested clipEnd of suggested clipSelect profile one by simply tapping the set button once. For these models select profile to tapMoreSelect profile one by simply tapping the set button once. For these models select profile to tap menu once the LED will blink twice.
How do I pair my Traxxas transmitter and receiver?
0:131:15How to Bind a Traxxas Transmitter and Receiver - YouTubeYouTubeStart of suggested clipEnd of suggested clipFollow this simple procedure make sure the transmitter and vehicle are both powered off open theMoreFollow this simple procedure make sure the transmitter and vehicle are both powered off open the receiver box for access to the link button on the receiver.
What are the advantages of Traxxas radio control vehicles?
One advantage of Traxxas radio control vehicles is that regardless of the damage the vehicle has stustained, it will always be repairable. If you're new to the hobby and don't know where to begin, there is an easy 3 step process any hobbyist can take to economically repair his or her vehicle: Survey the damage.
How long does Traxxas warranty last?
Traxxas warranties against manufacturing defects in the electronics for 30 days from the date of purchase. If the part was damaged upon initial inspection or if you feel that the part failed prematurely, be sure to check this link for details.
Introduction
If receivers don’t bind with the transmitter, the car won’t start. It’s a problem that makes users want to tear their hair off. That’s where we come in. We’ll help you fix this issue.
FAQs
Answer: There are some really good receivers available on the market. You could try Spektrum or Futaba receivers. FLYSKY receivers are also making a name for themselves.
Conclusion
That’s all we have for you today when it comes to why Traxxas receiver won’t bind.
Introduction
Is your Traxxas M41 encountering various issues? We understand why it’s frustrating. Being confronted with these problems is a difficult situation to be in. We’ve got you covered with the solutions.
Traxxas M41 Problems: 5 Simple Solutions
Electronic devices can make our lives complicated. Traxxas M41 is no different. You could run into a slew of issues. You could run into a slew of issues. The following are among the most common problems you’re likely to face-
FAQS
Answer: Look for carbon debris in the exhaust port if your RC won’t accelerate. The spark arrestor on your boat might also have debris. Cleaning these areas will likely fix the issue. Maintain cautious throughout the process.
How to retract a telescoping antenna?
Instead, retract it by grasping it lightly and sliding it down one section or two at a time . Although the telescoping metal antennae seem quite sturdy, they can bend and break quite easily.
How to make a radio antenna not drag?
To make sure that the antenna won’t drag, you can thread it through an antenna tube or try using soda straws, hollow coffee stirrers, or any semi-rigid plastic material. Some radios may work well with shorter antennas, but only cut the receiver antenna if the manufacturer endorses that.
How to protect antenna from metal?
Threading the antenna through a piece of flexible tubing (fuel tubing, for example) or using a strip of electrical tape to wrap it will help to save it from damage and prevent it from touching metal. Try as much as possible to keep the receiver antenna fully extended and not doubled-up or wrapped.
What is a transmitter antenna?
The transmitter antenna could be a solid metal tube, or it could be a piece of flexible wire that has an end cap (which may or may not retract into the controller) or a telescoping antenna where the sections pack inside each other when they are collapsed.
How does a car antenna work?
To ensure that long receiver antenna wires will not drag on the ground and get caught in the wheels of your car, the antenna is typically kept in a flexible (but quite rigid) piece of tubing. The antenna sticks up above the RC but stays flexible, so in a rollover or crash, it doesn’t break easily.
What to do if your RC antenna is broken?
If your RC car antenna has just gotten broken, the most feasible step would be to purchase a new one that fits your car or even just make a new one. We’re going to start by showing how you can make your own new RC antenna. Some people cannot afford to buy a new RC antenna, or if you are not near a shop or able to get overnight shipping, ...
What to use to thread antenna wire?
In order to have an easier time threading the antenna wire through the tubing, you can use a little oil to lubricate it, but keep in mind that oil can get sticky, and it also attracts dirt and dust. Talcum powder is an alternative lubricant you can use.
