
Full Answer
Why is my Wii controller not turning on?
- Turn the Wii console on and wait until the "Health & Safety" screen appears (don't press A).
- Open the SD Card slot cover on the front of the Wii console and press and hold the red SYNC button for 15 seconds. ...
- Resync the Wii Remote by removing the battery cover and pressing the red 'SYNC' button. ...
How to fix a Nintendo Wii controller?
- Next came the microSD card slot screw, which wasn't as tightly attached.
- Then came two Phillips-head screws on the bottom, on either side of the USB-C port.
- Then, a Phillips-head screw just to the side of the top vent.
- Then, the middlemost screw on the side rails where the Joy-Cons normally slide in, one on each side.
How do I Sync My controller to my Wii?
Syncing with the Wii U
- Open the Wii U Menu on screen and press the Sync button on the front of your console. This brings up the pairing screen.
- Pres the Sync button again until you see the controller you want to sync with the system.
- Remove the battery cover from your Wii controller to press the Sync button. ...
How to remove batteries from a Wii controller?
Remove the two screws, and then pull the battery pack straight up and off of the back cover. Note that the correct polarity of the batteries is marked on the housing. Use a knife or small flathead screwdriver to pry the two halves of the housing apart. Luckily these separate cleanly since they are not glued together.

How can I fix my Wii controller?
0:003:18How to Fix Wii Remote Not Turning on | Wiimote Battery Corrosion CleaningYouTubeStart of suggested clipEnd of suggested clipSet i'm actually going to take two flat head screwdrivers.MoreSet i'm actually going to take two flat head screwdrivers.
Why do Wii Remotes stop working?
If you have fresh batteries that are making good connections inside of the Nintendo Wii Remote, but the remote still does not turn on, there may be a poor power button connection. The connection between the power button and the motherboard may be dirty, causing the remote not to turn on.
Why is my Wii Remote blinking but not turning on?
There can be many reasons as to why the Wii Remote's lights are only flashing but not connecting. The most common cause is that the Wii Remote is no longer synced to the main console. It could have previously been synced but is now not synced for many reasons.
How long do Wii Remotes last?
A fresh set of alkaline batteries should last, depending on amount and type of use, up to 30 hours. This can vary greatly based on certain factors such as Wii Remote Speaker Volume, Rumble, battery quality and age, and the type of game being played.
Can I use my phone as a Wii Remote?
The free application called iFun, developed by gaming company SGN, gives you the ability to use your iPhone as a controller for the Nintendo Wii gaming system. The application uses the iPhone's internal accelerometer and touch screen to control the action of your Wii game.
How to clean Wii remote buttons?
To clean the buttons, you will need a NEW toothbrush, some warm water and a little soap. Remove the batteries from your remote before cleaning your buttons. Slightly dampen the toothbrush with warm soapy water and brush around the sticky buttons. Dry off with a paper towel.
How to calibrate a Wii remote?
To re-calibrate the remote, place it on a table button side down for 10 seconds. Make sure the Wii Remote is orientated parallel with your TV screen. After 10 seconds, point the Wii Remote back at the TV. If this doesn't work, go into the Wii settings at the home screen and make sure that the location of your sensor bar is correct, either below or above your TV.
Why won't my Wii remote turn on?
You have fresh batteries making good connections in the Wii Remote, but the remote still doesn't turn on. The connection between the power button and the motherboard may be dirty and causing the remote not to turn on.
How long does it take for a Wii remote to work?
After 10 seconds, point the Wii Remote back at the TV. If this doesn't work, go into the Wii settings at the home screen and make sure that the location of your sensor bar is correct, either below or above your TV.
Why is my Wii cursor sporadic?
Make sure that there aren't any lamps placed too close to the sensor bar because the mixed heat signals will cause the sporadic cursor. Also, make sure there are not any infrared lamps in the same room as your Wii for this will also affect the sensor bar.
Why does my Wii Tennis remote not swoosh?
This indicates that there is a problem with the internal speakers of your Wii Remote. This is usually caused by dirt and dust getting into the remote. To replace speakers, see our nifty guide for installing a new speaker.
What is the heart of a Wii remote?
The motherboard is the heart of the Wii Remote. The motherboard transmits signals throughout the Wii Remote, which includes the signal to turn on the remote when you press the power button. If gone through all the other steps, your problem could be a broken or burnout motherboard. Use our guide to install a new motherboard.
How to reset Wii remote control?
First, turn off and unplug your Wii gaming system. Leave the unit unplugged for one minute and then plug the gaming system back in. Turn the Wii system on.
How to fix Wii remote not turning on?
If your Wii remote won't turn on or doesn't respond, try holding the Wii Remote upside-down with the buttons facing downward. Tap the remote firmly against the palm of your hand three times to remove any dust sitting between the buttons and the electronic circuit board inside the remote. Turn the remote upright and press one of the buttons. If the problem continues, you might proceed by checking the hardware configuration.
How to get back to playing Wii games?
To get back to playing your favorite games, you can take some steps to check your hardware configuration, clean the remote and reset the remote control's settings. For additional help or to order a replacement Wii Remote, you can contact Nintendo's customer service department at (800) 255-3700. Advertisement.
Where is the sync button on a Wii remote?
The "SYNC" button is behind the small door on the front of your Wii unit. Release the "SYNC" button. Remove the battery cover and batteries/battery pack from the back of your Wii Remote. Press and release the red button located under the battery compartment. The blue lights on the front of the remote will blink.
Where is the sensor bar on a Wii?
First, check that the Sensor Bar cable is inserted firmly into the back of your Wii gaming system. The Sensor Bar also needs to be centered above or below your television so the Wii Remote can transmit signals to the gaming system.
When did the Wii come out?
Image Credit: jacktheflipper/iStock Editorial/GettyImages. Released way back in 2006, the Nintendo Wii gaming system requires remote controls to navigate the system's menus, control the hardware and play your games. If you've had your Wii a long time, you might find that your Wii remote won't turn on or your Wii remote is not working as it used to.
What is a Wii remote?
The Wii Remote is Nintendo's original motion-sensing controller for the Wii console released on November 19, 2006. The Wii Remote, nicknamed the "Wiimote", is a rectangular controller with a set of buttons on the top, one trigger style button on the bottom, and a screen on one end. It is usually white, however it is also sold in black, pink, blue, and red. The controller includes a set of buttons on the top, a trigger style button on the bottom, and a screen on the end. The model number for the Wii Remote is RVL-003, and is located both under the batteries and beneath the Nunchuk port.
Where is the model number on the Wii Remote?
The model number for the Wii Remote is RVL-003, and is located both under the batteries and beneath the Nunchuk port. The Wii Remote looks very similar to it's successor, the Wii Remote plus, except the original Wii Remote has no text underneath the Wii symbol on the controller.
What color is the Wii Remote Plus?
The Wii Remote is sold primarily in white while the Wii Remote Plus is usually black , but they are both sold in alternative colors. The Wii Remote should not be confused with the Wii Numchuck, the secondary joystick controller that plugs into the Wii Remote.
How to reset Wii remote?
Take the remote button side down, and slap the button side of the remote against the palm of your hand. This doesn't take a lot of force. Reset the Wii Remote. Remove the batteries from the Wii Remote.
How far away from TV should I put Wii remote?
Ensure the Wii Remote is being used between 3 and 10 feet directly in front of the TV. If the Sensor Bar is being used on top of a cable box, satellite box, or other top-box, remove it and place it directly on the top or bottom of the TV. Check for physical damage.
What to do if you have an unlicensed battery?
If you are using an unlicensed accessory, replacing it with a licensed accessory may resolve the issue. Ensure you are using a fresh set of alkaline batteries. Unlicensed rechargeable battery packs, lithium ion, and nickel cadmium (nicad) are not recommended and should be avoided.
Tools
These are some common tools used to work on this device. You might not need every tool for every procedure.
Troubleshooting
Diagnose the problems ailing your Wii using the Nintendo Wii Troubleshooting page.
Identification and Background
The Nintendo Wii, released in North America in November 2006, is Nintendo's seventh generation gaming console, a category which includes Sony's PlayStation 3 and Microsoft's Xbox 360. It is the smallest of the seventh generation consoles, measuring a slim 44 mm wide, 157 mm tall, and 215.4 mm deep.
Introduction
Sometimes when remotes stop working, the problem could be from old batteries left in the remote that leaked battery acid and caused corrosion to appear. This guide will help you take apart and clean the corroded areas in a Nintendo Wii remote.
Step 2
Using an opening tool, apply pressure to the tabs located near the "A" button.
Step 3
To remove the motherboard, press up on the "B" button, and then the connector at the bottom.
Step 7
Clean the terminals with isopropyl alcohol and a toothbrush or Q-tips.
